answersLogoWhite

0


Best Answer

Normally one finds the most obvious sign is a rougher than normal idle. I have a 2000 Mustang and found that occasionally the idle was rougher than normal and sometimes the car seemed to have less power. Again, this was occasionally and became worse and worse over time. I replaced the EGR and cleaned out the intake manifold passage to correct the problem.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Symptoms of a bad egr valve 1995 mustang gt?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are symptoms of bad valve lifter?

on a 98 ford taurus what are the symptoms of a bad hydralic valve lifter


Smoking out of valve cover breather on a ford mustang?

PVC valve is bad


Symptoms of bad egr valve is bad on 1995 aurora?

My Aurora had a slight hesitation or rpm surge at about 1500 rpm. disconnecting the electrical connector from the EGR valve and the problem went away.


What are the symptoms of a bad EGR valve in a 2000 Saturn SL?

A bad EGR valve in a 2000 Saturn can have several symptoms. The EGR valve can cause misfires, the valve can cause vacuum leak style problems. There could also be an engine knock.


What are the symptoms of a bad modulator valve?

it bangs when you put it in gear


What are the symptoms of bad ccv valve?

Check engine lit goes on.


Can an egr valve go bad on 1995 blazer?

Yes.


What are symptoms of a bad PCV valve?

valve should rattle when shook, and when engine is started it should have a good suction.


Will the purge valve on a 1995 S10 Blazer make the car die if it is bad?

No.


What are the symptoms of a bad intake air valve?

An engine with a bad intake valve is likely to backfire frequently. This can easily destroy a carbuerator or throttle body. The same symptoms can be caused by a poorly adjusted rocker arm or poorly timed cam and distributor.


Signs of bad PCV valve in 2002 mustang gt?

I also have a 2002 Mustang GT with a bad PCV valve. It made a ticking noise while the motor was running then ticked for 3-4 seconds after it was turned off. A way to test if it is a bad PCV valve is to remove it and see if the noise stops. It is in the right head just under the intake hose. Lift it out and if the noise stops there is your problem. It's a five dollar fix.


What are symptoms of a bad timing belt in a 1995 Chrysler?

engine cranks over but will not start.