answersLogoWhite

0


Best Answer

get the right clip releases and take off the front panel of the radio, slide clip releases down the sides of the radio and pulls out slowly, when theres enough room reach behind and unclip the wiring harness from the radio and unhook the antennae wire and you have your radio out

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Take radio out of a 1999 buick park ave?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 1999 Buick park avenue transmission fit in a 1995 Buick regal?

Depends on the engine the Park Avenue had in it.


Where is the fuse for the power antenna on a 1992 buick park ave?

Radio fuse


Why is my 1999 buick century hard to pull out of park?

Shift Cable


Where is the defogger module on 1999 Buick park ave?

My 97 Buick defogger module is in the rear leftinside panel.


2000 buick park ave ultra where is the radio fuse?

under the back seat


Where is the flasher located in a 1999 buick park ave?

The flasher on a 1999 Park aver is located under the dash. It is just to the right of the steering column.


Where is fuse box on a 1999 Buick Park Avenue?

under the back seat....


Horn location for a 1999 Buick park avenue?

The horn location for a 1999 Buick Park Avenue is along the front of the engine compartment, near the right headlight. It is directed outward to help the sound travel further.


Will 20 inch rims fit on your 1999 Buick Park Avenue?

It will always depend.


Firing order of 1999 buick park avenue?

The firing order of a 1999 Buick Park Avenue is 1, 2, 3, 4, 5, 6. The number one cylinder in this car is the one that is located closest to the car's belts.


What would cause the radio and heater blower motor to not turn on on a 2001 Buick Park Avenue?

FUSE!


1999 Buick park ave shaking at 60 mph?

I had this problem on a 99 Buick park Ave, and it was two bad tires and a bent rim. If you take it to a tire shop they can tell you what is going on. Also have them check tie-rod ends and ball joints as mine needed these also.