answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2007-05-08 16:12:22
2007-05-08 16:12:22

Does it turn over? Does it turn over?

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Check the 92 Camaro neutral safety switch next. If the switch is faulty then the starter will not get power to start the engine.



Nope, i can start my 720 without clutch engaged. Its a 1984 720 with the z24 motor if you were wondering


Stand safety switch or clutch switch



the clutch has to be pushed in to start. there is a switch under the dash probably knocked it out of position. while changing cable.


the magneto or alternator should allow the coil enough power to run your bike. if theres is no battery unfortunatley you wont be able to use the electric start but there is an alternative. assuming you dont have a kick start all you need to do is put it into 2nd gear, hold the clutch and push the bike till you pick up a little speed then let the clutch go and itll pop and turn on just make sure you pull the clutch back in after it starts so it doesnt drag you around the yard


Start with checking the fuses.



if the engine is blown up it wont crank over at all. or the kick starter could not be big enough to turn the crank. and if you really want to ride it pull in the clutch kick it into 2nd gear have some one help you roll it down the road as fast as you can get it going and pop the clutch to start it


Turn the wheel and then try to start it with the key.


Is your clutch pedal depressed? If it is, check switch on clutch pedal.


Need to know what is moving primary clutch, secondary clutch, can track be moved by hand.


my clutch went to the floor what happened?


Maybe something with the safety switch on the clutch, or the wiring going to the starter. May be ignition switch also.


The A/C Compressor may not be charged with frion if the A/C Clutch does engage, or it may not engage due to fact it's not sending 12v to the electronic wiring. First start the engine and turn on the A/C, watch if the clutch on the compressor engages or not.


After you engage a gear and let out the clutch and accelerate the car wont move faster but the RPM's will move up. Also in some rare instances when a clutch disk material separates from the disk its self you wont be able to start the car or even change gears.


if the car does a click like it is going to turn OS but wont then yes it is the starter


There is normally a second starter-position solenoid under the clutch pedal. It probably is not getting contacted when you step on the pedal.



It is likely broken if there is power to the outlet


I do not have a answer for it, do you an answer for this problem?


Try replacing your spak plugs. I had the same problem with my 85 Monte Carlo.



Your battery is dead (even though you have some power), jump start it and when car is running test voltage to see if alternator needs to be replaced. Also ensure battery terminals are properly secure if you have no luck.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.