No way,man! It'll get thrown out (and maybe right in your eye!) when you turn on the drill.
Tighten the drill bit in the chuck.
goes with a drill to tighten the neck around the drill bit.The end of a drill where the bit goes is called a chuck. You use a key to tighten it to hold the bit. It is not a key like a house key but a gear that matches the teeth on the chuck.
Hold the chuck in your left hand and barely tap the trigger while in reverse. The chuck should open up. (If not reverse the drill direction) Drop the drill bit into the chuck. Again hold the chuck and tap the trigger while in forward. The jaws should tighten around the bit. If the drill uses a key, use the key to tighten the chuck further. If chuckless, again hold the left half of the chuck in your left hand, the right hand part of the chuck in your right hand and twist your Right hand clockwise 'till snug. If none of this makes sense, these terms are new for you, set the drill down... slowly back away and call some one to help you learn more about the equipment you are using.
Chuck May is 6' 4".
A chuck that has a construction that allows you to tighten or loosen it without the use of a key.
yes i may so how much wood could a wood chuck chuck if a wood chuck could chuck would
Chuck May goes by ChucGyver.
A 'chuck key ' is used, there are 2-3 sizes.
You may have left the car in drive
There are two types of chuck. One clamps up by hand, twisting holder against chuck base. Others have a serrated edge and need a chuck key.
Chuck Vincent died on September 23, 1991, in Key West, Florida, USA of AIDS.
Mag Aral kayo Mabuti. Wag Puro Research. :P