Computers
Nissan Maxima
Computer Worms

The cruise control on a 2000 Maxima is not engaging due to a computer malfuction Is it possible to reset the computer or does it need to be replaced?

262728

Top Answer
User Avatar
Wiki User
2007-01-13 05:55:59
2007-01-13 05:55:59

Answer: Just Like a home PC Computer, or a satellite receiver, sometimes they just need a re-boot, (turning the power off for a few mintues). Try disconnecting positive terminal from battery for a period of 30 to 60 minutes, to attempt clearing (re-boot)computer ?

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Computer have replaced man power?

User Avatar

= "Do you have to flash the computer after you replaced the engine?" =

User Avatar

If the computer does not log you off automatically when it enters standby, then yes. Also, this could be a sign of a faulty sound card that needs to be replaced.

User Avatar

Answerit could be the wiring from the sensor Adding to that. On most GM engines, there are multiple (usually two) Temp Senders. One for the dash, the other for the computer. Its possible that just the one for the PCM (computer) was replaced.

User Avatar

Pcm internal failure. The engine computer has failed a self test.The computer may need replaced.Pcm internal failure. The engine computer has failed a self test.The computer may need replaced.

User Avatar

Did you just turn it on from the dash or turn it on and then attempt to engage it with the wiper stick?

User Avatar

The computer only resets when the battery is removed. The alternator just charges the battery, so if the battery is left connected when the alternator is replaced, the computer should not reset.

User Avatar

A PATA can be used to connect older hard drives to a computer internally, as it was a common interface. The PATA format has largely been replaced by SATA.

User Avatar

It is possible that the sunroof motor needs to be replaced if the sunroof is not closing automatically. It is also possible that the wiring needs to be replaced.

User Avatar

If your iPod's screen is cracked or broken, it is possible to get the screen replaced (for a charge).

User Avatar

It will be replaced. The file that is being replaced gets deleted/overwritten with the one that is being copied over it. This is only possible if the two files have the exact same file-name and extension, provided the file being replaced isn't write-protected. Size and date are not relevant.

User Avatar

"The series circuit can be replaced, however it is not an easy task and it is best left up to professionals in computer repair unless you have extensive experience with computers."

User Avatar

P0601 : internal controller processor failureThe engine computer will need replaced.P0601 : internal controller processor failureThe engine computer will need replaced.

User Avatar

That is an internal transmission computer failure code. The tcm needs replaced.That is an internal transmission computer failure code. The tcm needs replaced.

User Avatar

It is possible to do so - you will need to contact your optician.

User Avatar

clutch in transmission isn't engaging correctly, must see a transmission guy to know, and transmission would have to be replaced. Other possible is the wires going to the fuel injectors are shorting at the 8 pin connector. There are on engine near air intake.

User Avatar

The regulator is in the engine computer, and if failed the computer will need replaced.

User Avatar

The on-board computer is factory installed and cannot be 'reset' - it must be replaced.

User Avatar

nothing yet. you are using an electronic computer.

User Avatar

typewriters (replaced by a keyboard and word processor) teletype and facimile machines (replaced by emails and scanned documents) calculators (still in use but replaced by spreadhseet programs) ledger books (replaced by accounting packages) etc..

User Avatar

One may have a computer motherboard replaced in Toronto, Canada at a business named Laptop Specialist. They are located at 2914 Shephard Ave. Toronto.

User Avatar

I believe you can but normally when it engages low its a sign that the clutch should be replaced soon.

User Avatar

the front diff is not engaging its not the transfer case which is manual the solenoid needs replaced


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.