1 and 1 1/4
Loosen the motor mount retaining bolt. Jack the motor up a few inches. Remove the motor mount retaining bolt and the motor mount bushing. Reverse the process to install the new motor mount.
Put the new motor mount bushing into the appropriate place. Put the motor mount retaining bolt in. Let the engine down from the jack. Tighten the motor mount bolt.
Each motor mount is held in place by a retaining bolt. The retaining bolt goes through the middle of the motor mount. Remove the retaining bolt. Jack the engine up. Replace the motor mount.
You can replace your 1995 Chevy Corsica motor mount by loosening the motor mount retaining bolt. Jack the engine up approximately 3 inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.
Begin by loosening the motor mount retaining bolt. Jack the engine up a few inches. Remove the motor mount bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.
The motor mount bolt size for a 1996 Windstar 3.8 is cross-thread a 3/8" bolt. That is the only bolts that will fit.
The 1994 Ford Thunderbird motor mounts are secured with a bolt and nut running through the middle of the motor mount. Loosen the nut and pull the bolt out.
Yes.
It is best to change one motor mounts one at a time. Loosen the motor mount retaining bolt. Jack the engine up a few inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new bushing in and reverse the process.
undo large bolt that goes through the motor mount and take the bolt out and jack that side of the engine up and replace the mount and lower down and reinstall long bolt and do the same to the other side, very simple to do.
To replace a motor mount on a 1995 Chevy S-10 4-cylinder 2.2L, the engine will need to be hoisted up out of the vehicle until the new motor mount is welded in, if the mount is rusted out. Then lower the engine, keeping it on the hoist until both motor mounts are secured. Then, it will be necessary to hook up all other parts to the motor, like the transmission. If the motor mount is only missing the bolt, then replace the bolt with a new one.
Begin by loosening the motor mount retaining bolt in your 1993 Geo Metro. Jack the engine up a few inches. Remove the retaining bolt and the motor mount bushing. Put the new bushing in and reverse the process.