0
It can be up to 40 percent in modern plants, less in old ones
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Furnace used in thermal power plant How this furnace works in heating the boiler?
A Furnace works by heating the power plant with the fuel provided you idiot... how else do you think it works??
What is oil thermal power plant?
The oil thermal plant refers to the chemical energy that is stored in the fossil fuel like the natural gas, oil shale, fuel oil, and coal. They are usually successively converted into thermal energy, mechanical energy, and electrical energy.
What is dearater in thermal power plant?
It removes the gases present in the steam,given by heaters.dearater is necessary otherwise the gases in steam will corrode the boiler and also affect the turbine.
Operation of a combined cycle power plant?
A combined cycle power plant has multiple thermodynamic cycles. This increases efficiency. For example, a gas turbine can be used to produce electricity, but only about 40% of the heat is actually converted in the process. 60% of the heat is lost, and in a single cycle plant would be considered waste heat. In a combined cycle plant, that waste heat could be used to drive a second, steam turbine to produce more electricity. In such a case, the efficiency could be increased from 40% to nearly 60%. It is possible to go further. The waste heat from the combined cycle electric plant can be used to heat buildings, for instance, increasing overall efficiency to more than 65%. This is called Cogeneration.
What kind of power plant is NAPOCOR?
NAPOCOR is not a power plant. It is a power company. It is the National Power Corporation of the Phillipines.
What is the example of thermal power plant?
A good example of a thermal power plant is run that is coal fired.
Which power plant has maximum efficiency?
thermal
What is the efficiency of thermal power plant?
A modern combined cycle gas turbine/ steam turbine power plant can reach almost 60% efficiency.
Efficiency of nuclear power plant?
PWR's and BWR's have thermal efficiencies around 33%, that is the generated power as opposed to the reactor thermal power.
What is the thermal efficiency of a plant?
The ratio of the power sent out by the plant to the energy produced from the fuel, in percent usually
What is oil fired thermal power plant?
An oil fired thermal power plant is one which heats up oil so as to supply the heat needed to heat water and produce steam. They differ from nuclear power plants which rely on nuclear fusion.
Which is the main fuel is used in Kayamkulam Thermal power station?
The Kayamkulam Power Plant, in Kerala, India, is a 350 MW Gas Fired Plant.
Which is worlds biggest nuclear power plant?
4x1000MW coal-fired ultra-supercritical power plant at Yuhuan in China is supposed to be the world's bidgest coal power plant. Plant is located on the coast of East China's Zhejiang Province. The last (4th) unit of plant began commercial operation in November 2007. The plant run at about 45% thermal efficiency. Yuhuan Units are supposed to be the most cleanest, most efficient and most advanced ultra super critical units of today's world." Vivek Asthana Panki Thermal Power Station, Kanpur
-if a generator in an oil-thermal power plant is 35 percent efficient and its output capacity is 3 000 MW what is the output power for the turbine generator system?
If the oil fired furnaces produce 3000 MW thermal, and the overall station efficiency is 35 percent, this means that the electrical power sent out is 1050 MWe. This assumes you do mean the overall station efficiency, ie that the power used for auxiliaries on the station is subtracted from the total electric power generated, before this figure is calculated.
Temperature measurement in thermal power plant?
how to measure Temperature in thermal power plant
When was Taketoyo Thermal Power Plant created?
Taketoyo Thermal Power Plant was created in 1966.
Efficiency of thermal power plant depend on how many factor?
1. digen of furnace. 2. quility of coal. 3.proper operation
