0
Head torque sequence for a 2002 3800
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Torque specs for 1991 Buick 3800 V6?
Need more info. Torque specs. for what?
What are the torque specs on a GM 3800 engine?
horsepower : 200@ 5200 rpm torque : 225@ 4000 rpm
How to replace intake manafold on V6 3800 engine?
Ineed the torque sequence and tightening specs for a 92 GM 3800 intake.
What are the torque specs for a Pontiac 3.8 intake manifold?
I'm pretty sure this is that same 3800 motor that gm uses in my mom's 2001 buick Le Sabre. Her intake was the fiberglass resin plastic and the torque specs are 89 INCH pounds. Make sure you use the right tightening sequence too. 89 inch pounds is for the upper intake or Plenum. 136 inch pounds is the torque specs for the lower intake
Can you put the heads of a 3800 Chevy Monte Carlo on the motor of a 3400 Chevy Monte Carlo?
No
What is the hp and torque of 1976 454 truck motor?
Advertised Horsepower is--245 HP @ 3800 RPMs. Torque is-365 FT. LBS. @ 2800 RPMs. The Heavy Duty 454 has--240 HP @ 3800 RPMs. Torque is--370 FT. LBS. @ 2800 RPMs.
Do they fit Oldsmobile 3800 series 2 heads to 98 camaro 3800 series?
I think so, though the exhaust ports may be slightly larger on the FWD motor, but they are all GM heads.... they will fit but they are differnet the fwd have the fuel injectors in the head where the rwd has them in the lower intake manifold.
Will a supercharger off an 1989 riviera 3800 series motor go on a 2000 grand prix 3800 series motor?
No
What is the torque on head bolts for a 3800 Pontiac engine?
The 3800 Pontiac engine had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
Will a 1989 Oldsmobile delta 98 3800 motor fit in 1993 Pontiac Bonneville SE 3800?
don't think motor mounts will work - look for 92-99 3800
What is the upper and lower intake manifold bolt torque setting on GM 3800 series 2?
Ignore the specs. Work inside to out, tightening a little at a time. Should take you 6 or 7 runs through. Make them tight, but dont force them. I tightened to specs and had horrible leaks. With this method, perfect.
What are the Rod and main torque specs for 99 supercharged buick?
3800 gm (supercharged does not change) Mains: 30Ft-lbs, then tighten 110 degrees sides:11 then tighten 45 degrees Rods:20 thentighten 50 degrees I got this from my haynes manual, I would highly suggest getting on as these a very important torque specs.......as well as many others required for engine building.
