0
horsepower : 200@ 5200 rpm
torque : 225@ 4000 rpm
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How to replace intake manafold on V6 3800 engine?
Ineed the torque sequence and tightening specs for a 92 GM 3800 intake.
What are the engine torque specs for a 1977 Buick Skylark engine?
A GM dealer's service center would know.
Head bolt torque specs for 1989 caprice?
I can help you out if i know the engine size. If you can provide me with that i can look it up in my GM torque spec book.
WHAT are the torque specs for a 3.4 liter gm engine?
If you mean the 3.4 liter LA1 engine, you should expect between 205 and 210 foot pounds of torque, and between 170 to 185 horsepower.
What are the Rod and main torque specs for 99 supercharged buick?
3800 gm (supercharged does not change) Mains: 30Ft-lbs, then tighten 110 degrees sides:11 then tighten 45 degrees Rods:20 thentighten 50 degrees I got this from my haynes manual, I would highly suggest getting on as these a very important torque specs.......as well as many others required for engine building.
Whats the hp and torque specs on the 99 sunfire GT?
140 hp not sure on the torque Actually GM listed the 2.4 litre engine at 150 hp and 155 lb/ft torque.
What are the GM body bolt specs for a 2011 Chevy silverado?
what are the torque specs on body mount bolts
What is the difference between the 3800 series 2 and 3800 series 3 gm engine?
About 20hp.
What are the torque specs for a Pontiac 3.8 intake manifold?
I'm pretty sure this is that same 3800 motor that gm uses in my mom's 2001 buick Le Sabre. Her intake was the fiberglass resin plastic and the torque specs are 89 INCH pounds. Make sure you use the right tightening sequence too. 89 inch pounds is for the upper intake or Plenum. 136 inch pounds is the torque specs for the lower intake
What is considered low oil pressure on gm 3800 v6 engine?
80lbs
What is the upper and lower intake manifold bolt torque setting on GM 3800 series 2?
Ignore the specs. Work inside to out, tightening a little at a time. Should take you 6 or 7 runs through. Make them tight, but dont force them. I tightened to specs and had horrible leaks. With this method, perfect.
What are the wheel lug torque specs on a 2002 GM 1500?
Without looking at the specs, would guess up around 100 foot pounds.
