there are small black circular pins around the shroud on top. pull them out and you will be able to access the bolt to the battery harness
First you want to disconnect your negative [-] battery cable and then your positive [+] then remove the battery hold-down bolts and remove the battery installation is in the reverse
Remove a battery connector. Remove the starter and put another in it's place.
Disconnect the 1990 Regal battery. Remove the alternator belt. Unhook the wiring from the alternator then unbolt it. Remove and replace the alternator then reconnect the wiring, belt, and reconnect the battery to finish the installation.
Remove the negative battery terminal from the battery first, then remove the wires from the back of the starter. Now remove the two bolts holding the starter in and remove the starter. Reverse these steps for installation.
Disconnect the battery cables. The battery has a clamp holding it in, probably along the bottom edge. Remove the clamp bolt. Pick up the battery. Reverse process for installation.
jack up paasenger side of vehicle remover tire then remove wheel well disconnect negative cable, positive cable, battery holddown and remove battery installation is reverseal of uninstall
Remove the air cleaner assembly, and the battery hold down bolt or bolts if you have two. There located on the bottom of the battery. Installation is reverse of removal instructions.
How to remove battery cover to replace battery
Remove the negative battery cable for 6 minutes and then replace.
Remove the Fuse box from the body, just one bolt and the bar clamp. Remove the bar that's on top, unscrew the battery holder and cables then lift it out. Reverse for installation.
Remove the seat. Remove the battery. Replace the battery. Replace the seat.
Jack up left front of vehicle and remove left front tire. Remove left front inner splash guard.remove battery holdown,negative battery terminal and thenpositive terminal.Remove battery through inner fender well and replace with new.reverse order for installation.