Transmission control unit for a 1990 Pontiac transport?

how do you rebuild 1990 bonneville transmission

I have the same problem with a 1994 Pontiac transport. So if anyone has an answer please help us.

I have a 1990 Pontiac Transport SE, I have the changed the motor on the driver's window which is power...take off the door panel and you will see the motor...not too difficult of a job...follow the old motor route...

I recently had a 1990 Chevy lumina apv 3.1L engine put into my 1992 Pontiac transport, if that answers your question.

yes it should bolt right up as well as the original motor and tranny

no switch,fan control is determined by the engine control unit with input from the coolant sensor

yes it will as long as they both are overdrive transmissions i just did it two weeks ago

last time I checked = 1-2-3-4-5-6...no kidding

check vehicle emission control info sticker located on right front shock tower under hood.numbers are visible on small metal plate with notches and numbers are attached to timing cover.clean with solvent to see numbers.

No it will not work. the transmission in the 1993 is electronically controlled and the 1990 doesn't have the wiring or modules to control it. the transmission from a 1991 would work but would require modifying or swapping shifter linkage at transmission.

what exactly is wrong?

BROKEN CRUISE CONTROL CABLE (CHECK AT THROTTLEBODY AND FOLLOW TO TRANSMISSION)

The 1990 Grand Am was a popular car. The curb weight of the 1990 Pontiac Grand Am was 2,739 pounds.

Emissions controls, fuel/air mixture, timing, and transmission.

It Is attached to the driver seat on the left side, or on the floor there is a little lever also on left side of the drivers seat.