A battery eliminator is a device that can be used to power a piece of equipment that is usually powered by batteries. It can be used to power things like radios, toys, and small electronic appliances.
It lets you run whatever it is from a wall outlet instead of from batteries.
You do not charge a battery using a battery eliminator. The eliminator is not a charger, it is an eliminator that allows you to run the device.
Yes. All you need is a battery eliminator with the right characteristics.
a battery eliminator is an electronic circuit which enables the user to run a device which is normally powered by a battery, by using outlet AC power without having to replace a run down battery. the pros for using a battery eliminator is that the device can run continously without having to replace any battery. the cons of using a battery eliminator is that the portablity / freedom to move anywhere without trailing cumbersome wires is lost. moreover the device should have a builtin receptacle to accept power from a battery eliminator. most importantly the user should preferably use a manufaturer supplied eliminator , since the user then does not have to know all the technical specifications and designs requirements which are needed to make your own battery eliminator. just for info , the following info is a must to construct a battery eliminator. 1 ) The outlet power supply voltage at the place of use & appropriate plug supply cord for the same which will be used to connect the eliminator 2 ) The device DC operating voltage & expected current drain in operation 3 ) The appropriate jack plug which will be suitable for the device and the polarity of the connection , since the output of the eliminator is DC. 4 ) A step down transformer of suitable rating as per points 1 & 2 5 ) Rectifier Diodes , Circuit board to mount the components , Electrolytic cap of rating as may be required with reference to pt.2 The output of stepdown transformer is fed to the rectifier device which converts the AC power available from the transformer to DC. A electrolytic capacitor is used to smoothen out the variations in DC output of the rectifier & make it simulate a constant battery voltage. This description is just for info since it is impossible to give a full construction detail here suitable for any application.
While 'rectifier' is the component which converts AC to DC, the entire converter unit which converts AC to DC is also known by the name 'Eliminator'.This, as the old timers will tell you, is short for 'Battery Eliminator', as quite often, the AC-DC converter is used as a substitute for having to use the batteries. It allows the battery driven equipment to be powered from the mains directly.
Right side small lockable cover is removed,you will see bottom of battery, take out screw from long side cover and pull off.
The cast of The Eliminator - 2004 includes: Dan Cade as Eliminator
There are a number of different good Callus Eliminator products. Some of the better ones are ProLinc Callus Eliminator and Be Natural Callus Eliminator.
First you connect a trnsformer to the main supply and then a rectfier .youmay connect a zener diode or a resistor or a capacitor as a filter circuit
The duration of The Eliminator - film - is 1.5 hours.
Mr. Eliminator was created in 1964-01.
yes they do you can buy them on amazon for about 3.00
Drag Race Eliminator was created in 1986.