answersLogoWhite

0

WHERE is the blower resistor located on a 2002 BMW X5?

Updated: 10/20/2022
User Avatar

Johnferreri

Lvl 1
14y ago

Best Answer

under passenger foot well - left side of blower case. remove lower kick panel to access module

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: WHERE is the blower resistor located on a 2002 BMW X5?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a blower resistor on a 2002 BMW 325i?

how to replace blower resister on a 325i BMW 2002


Where is the blower resistor located on a 1992 BMW 325i?

The blower resistor on the 1992 BMW 325i is located under the center console. It is found on the driver's side.


Where is the blower resistor located on a 1992 BMW 525i?

Blower resistor is under Drivers' side of center console


Why is my blower is intermittent on my 2002 BMW 525i?

sounds like a bad blower motor resistor and or plug


Why do my fan blower stay on all the time in a 2002 BMW 5 series?

bad blower switch located behind blower control.


How do you change the fan motor resistor of a 2002 325i BMW?

If you mean the HVAC fan, the resistor should be located within the fuse block.


Where is the blower resistor on a 1998 BMW z3?

Under the steering wheel panel


Where the ac blower is located on a 1999 BMW 528i?

I would like to know, where the ac blower is located on a 1999 BMW 528i


Where is the blower resistor on a 1988 325i BMW?

The blower resistor board is mounted underneat the blower motor. They are both accessible by taking off the long plastic cover at the top of the firewall from inside the engine compartment.


Where is the heater blower resistor located on a E36 BMW 318 SE?

on the left hand side of the car. (when you sittin in it). look behind the middle panel, close to firewall.


Where is battery located of BMW x5 2002?

where is battery located on bmw x5 2002


Where the Fuse is for the Heater Blower on a 2001 BMW 540i your blower is not working?

the most likely cause is not a fuse but the final stage blower resistor, its very easy to replace, it located near the right side footwell vent duct. remove the trim panel under the glove box, and the resistor is very visabl along with the connector, remove and replace resistor, experienced tech takes about 5mins. to do. good luck.