answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: W i start my 2000 gallant it idles real rough put in drive knocks and bangs when you go?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

99 Chevy silverado 4.8l it idles fine until you drive it then it idles up to 15-1700 rpm and wont stop till you shut it down then when i start it again it idles normally until i drive again why?

Probably a bad idle air control valve.


Your battery light comes on and your car stalls out when it idles you drive a 2003 caviler why does this happen?

replace the alternator


What would casue a 98 escort not to rev up after you hit something. it idles fine but it will not rev up in park or drive it only idles to move. i use it for enduro racing?

Sounds like the throttle cable is broken.


If You drive a 98 Olds Silhoutte it over heats almost immediately and sputters and idles low Same problem?

headgasket


Idles good but looses power in reverse or drive?

Need to run a fuel pressure test, and check the fuel filter.


Why does your 1987 Grand Wagoneer idle poorly in drive In park and neutral it idles great?

check your timing & up your idle a little


What are the mian reasons for supercharger failure there is a ticking noise why it idles and it kind of studers when you drive it doesnt want to do it?

supercharger coupler / bearings


What causes 93 camaro 3.4 run idles rough when its in drive or reverse?

More than likely... Tune up, or vacuum leak


Whats the problem of my car starts and idles but stalls when you put it in drive or reverse yes its an automatic the car is a 87 Nissan sentra?

Probably an alternator.


1993 lebaron stalls out when in drive but not when it idles and it stalled out 4 times within a quarter mile?

fuel pump, fuel filter, good place to start


You have a 96 silverado it idles high while in park 1500-2000rpm but in drive or reverse it goes to 1000rpm?

My '95 did the same thing. It was the Throttle position sensor.


Why would your car stop when you shift into Drive?

One possibility is a defective lock-up torque converter solenoid. If it runs and idles fine in then this would be what I would check first. Disconnect it and if it then stops stalling in drive, you have found the culprit.