If you are looking at motor from front and have cover removed it will be on left front of engine. It is small cylindrical cannister with hose out of each end. Look online at parts supplier for picture part # cp214
P0443 - EVAP control system CANISTER PURGE VALVE CIRCUIT MALFUNCTION - VPWR circuit open - Evap canister purge valve circuit shorted to ground - damaged EVAP canister purge valve - EVAP canister purge valve circuit open - EVAP canister purge valve circuit shorted to VPWR - damaged PCM
The computer on the car purges the evap canister automatically by activating the purge solenoid.The computer on the car purges the evap canister automatically by activating the purge solenoid.
most likely in the evap canister.
evap canister purge control valve circuit fault
Low purge flow- faultu evap valve or canister.
It is mounted up under the truck right next to the gas tank, in front of it.
P1445 EVAP Canister Purge Volume Control Valve
Behind the rear driverside tire,there is a flap with two screws you have to take out.
Under the car to the rear of the gas tank. Attached to the charcole canister filter.
by the tank or evap canister
The Evaporative Emission Control System monitors the fuel vapor flow between the engine intake manifold and the EVAP canister. The system failure occurs when a leak or blockage between the intake manifold, the EVAP canister purge valve and the EVAP canister is detected by the PCM. Code P1443 Possible Causes: - Pinched, blocked or plugged fuel vapor tubes/hoses (except between fuel tank and EVAP canister) - Damaged EVAP canister - Disconnected, cracked or cut fuel vapor tubes/hoses (except between fuel tank and EVAP canister) - Damaged EVAP canister purge valve
where is the evap purge valve located in a 1996 jimmy