The light is reset with a scan tool after the repair. There is not a button.
check engine
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
After repairing the cause of the code, you clear the code with a scan tool.
There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.
You can disconnect the negative battery cable, wait a couple minutes then reconnect the cable. This will clear the codes and reset the check engine light but, if the reason the light came on isn't fixed the light will come back on soon.
Press the odometer button while starting the vehicle. Keep holding down the button until the numbers disappear and the check engine light goes out. Release the button and all is well.
If the Bravada is not starting but the engine turns over, check for spark at the plugs. If there is no spark the ignition system will need troubleshooting to find the problem.
Sorry , there isn't a reset button - you have to have the Explorer scanned to find the trouble code(s) that caused the check engine light to come on . The problem has to be repaired before the check engine light can be turned off by using the OBD II scan tool
The check engine light on a BMW 525i is reset by pressing the trip reset button until the engine icon appears. The Check and DC buttons are used to navigate between menus and the trip button held to actual reset the selected error.
The computer has detected a problem with the emissions controls or something that effects emissions. Fix ASAP. It also can detect when you have not put your gas cap on tightly. The absence of a vacuum in the gas tank will cause the check engine light to come on as well. -Voice of experience. Possibility: When my Bravada had a "check engine soon" light come on it was because the O2 sensors were bad. The next time it came on was because when I had the fuel tank replaced the mechanic forgot to plug a sensor above the tank back in.
Is there a reset button on a 1996 rav4? Had it checked out, and said it need spark plugs and wires. Replaced it and check engine light still on.
If the problem was fixed, the check engine light should turn off after a certain amount of times of turning on and off the car.