somewhere on transmission by the axles
Trouble code P0500 means: Vehicle speed sensor malfunction
At around 90000km timing belt should be replaced!
The 2003 Saturn L200 does not have a camshaft position sensor.
== == 2002 L200 4 cyl. is a speed density system, therfore it is MAP. Please check this Carfax Reliability Rating... It shows this particular car has a MAF also: http://www.carfax.com/car_safety/ratings/SRR.cfm/year/2002/make/SATURN/model/L200 The L200 4 cylinder has a MAP sensor. The 3.0L v-6 has a MAF and a Map sensor. That may be causing the confusion.......
The mitsibushi eclipse.Definitly not the dodge charger
The 2003 Saturn L200 has a camshaft position sensor. It is located on the bottom front of engine behind the Starter. You will need to remove the two bolts that are holding the Starter to get to the sensor.
probably the dealership
hi i have a 2004 mitsubishi l200 ediesel that wont start,turns over but not firing,been told its the crank shaft position sensor
sensor is located in the ignition housing itself and can not be serviced seperatly from the housing, it must be replaced
No, the range sensor reads what gear or "range" you have shifted into.A speed sensor reads the speed of an item.No, the range sensor reads what gear or "range" you have shifted into.A speed sensor reads the speed of an item.
The speed sensor wire is connected to the speed sensor and goes to the speed sensor relay switch. The speed sensor relay switch is connected to the computer by a separate wire.
Need to know if you are asking about the vehicle speed sensor, a front wheel speed sensor or rear wheel speed sensor.