0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the spark plug gap on a 1988 Mercedes 190e 2.3?
Depending on the spark plug manufacturer, the plugs for a 1988 Mercedes 190E 2.3 should be gapped between .030" to .032". Bosch and Denso recommend .032", while NGK recommends .030".
Where do you find the differential fill plug on a 1987 Toyota Corolla FX16 with automatic transmission?
It has no differential plug.
What is the spark plug gap on a 1987 Mercedes 190E 23?
Gaps are from .028" thou to 0.035" thou. Preference is for 0.028" thou.
How do you remove spark plug wires from a Mercedes 190E?
To remove the spark plug wire in 190e one needs a long nosed plier. Next go for the metal part just above the plugs and grip them tightly and pull up. To fix it all you need to do is to push it with your fingers. Done
Where is the differential fill plug on a 1999 Toyota Camry?
Yes, you can find one the side of the differential facing the trunk.
What is the spark plug gap on a 1990 Mercedes 190E with the 26 inline 6 engine?
As per page 95 of the owners manual The electrode gap is 0.8 mm (0.032 in)
What is the spark plug gap 86 190E 2.6?
.045
How do you change the differential fluid on a 1997 CR-V?
To change differential fluid on a 1997 CR-V the vehicle needs to be lifted up to reach the rear differential. Find the drain plug located on the underside of the unit. Pull the plug and drain the fluid, when done place the plug back add fluid into the fill hole which is located topside of the differential.
Where is the oil pressure release valve on a 190E 2.6 diagrams please?
Mercedes 2.6 (m103) oil pressure reliefThe oil pressure relief valve on a Mercedes 190e 2.6 (103) is mounted in the oil pump housing. Access is by removing the sump where the oil pump housing is located at the front of the engine. The relief valve consists of four components, a screw plug, a compression spring, a guide pin, and a piston. Remove the screw plug and withdraw the spring the pin and the piston. Refit in the reverse order to removal and torque the screw plug to 50Nm.
Where is the rear differential plug on a 1999 ford expedition?
The rear differential plug is located on the inside top part of the differential. Where the drive shaft connects.
How do you replace the oxygen sensor on a 1992 Mercedes 190e 2.6?
unplug the connector, remove the oxygen sensor, it is located under the vehicle at the catalytic converter. install new oxygen sensor, plug in connector. done.
Where is the differential fill plug on a 1986 Mazda rx7?
The fill plug is on the end of the differential. To access this, you will need to crawl underneath your car, and lok at the middle of the axle. There are two plugs on the differential; a drain and a fill plug. The Fill plug is obviously the plug closer to the roof of the car.
