Take off the 3 bolts that hold it in, get it out, its a bit tricky so use some force, then once you get it out, take the caps off and your there.
The regulator is part of the engine computer. It is expensive and has some important steps involved to replace.
What steps are involved in changing an alternator on a 2002 dodge grand caravan?
I have a brand new parts on a 1996 dodge avenger i just put a brand new crank sensor why won't it start rite up and also it turns over but wont fire will new spark plugs work. The first steps are to check for codes, and check fuel pressure.
CHECK THE OWNERS MANUAL IN PG. 102 FOLLOW FOUR SIMPLE STEPS.
I don't think so, they're two totally different headlight assembly's, but then again I may be wrong, auto companys are always using the cheaper way out. Just take it apart anyway, and record your steps as you go so you'll be able to put it back together.
The horn is located behind the drivers headlight. To remove unplug harness, undo bolt in bumper assembly behind drivers headlight (must be removed first), and it slides out. To install new, follow steps in reverse.
Unplug old sensor, unscrew with a 7/8 inch wrench. Reverse steps to install.
There are 3 wing nuts holding head light bracket, remove these and unplug wire, lift out bracket, then remove headlight from bracket.
You will see the plastic connectors on the back of the headlight mounting plate. Twist to the left while pushing inward. Reverse steps to put it back.
1) Open hood. 2) Look behind whichever light is out to make sure what connector to pull out. 3) Twist the connector until it stops. IT WILL NOT PULL OUT YET 4) There is a metal spring/clip thing that is holding the connector in the headlight assembly, unclip it, do not take it out... 5) Pull out and replace bulb as necessary 6) Test headlights for operation before putting back together 7) Clip that stupid clip. 8) Twist connector back into position, and your done. Very easy, I've done it in a Autozone parking lot, at night.
To remove the headlight you must open the hood and pull the white tab slide located on top of the headlight assembly. It pulls strait up. You must use caution as these break all too often. You do not need to completely remove the slide to remove the headlight once pulled up the headlight should slide out forward with a little wiggling. Then you can replace all of the bulbs in the headlamp assembly. To put the headlight back into place reverse the steps.
Pull it out of the valve cover, twist it out of the hose from the intake. Reverse steps to reinstall.Pull it out of the valve cover, twist it out of the hose from the intake. Reverse steps to reinstall.