answersLogoWhite

0


Best Answer

warped rotors , bad brakes,tie rods, tiresbad ,

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What Causes Vibration on my 2000 Chevy Prizm?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Diagram of serpentine belt 2000 Chevy Prizm?

replacing serpentine belt on 2000 chevy prizm need help


Chevy Prizm 2000 has timing belt or chain?

Chain


What size tire for 2000 geo prizm?

i don't know, as that car does not exist. prizm went to Chevy in 1998.


What is code PO420 on a 2000 Chevy Prizm?

catalyst system fault


How do you open locked doors with out keys on 2000-2003 Chevy Prizm?

call a locksmith


Will a Toyota corolla headlight 1998-2000 fit a Chevy Prizm 1998-2002?

yes


How do you find a blow motor resister on 2000 Chevy Prizm?

I know on my '98 Prizm it is accessible from the inside down low on the passenger side. Not an overwhelming job.


Where is the Chevy Prizm 2000 cabin air filter?

inside the radiator,but you need to change when the radiator is to hot.ok.


How many cold cranking amps are recommended for a 2000 Chevy Prizm?

If you live in a cold climate the more the better.


What causes a vibration in the left front when driving a 2000 Chevy venture?

I also have a 2000 Venture same problem. Solution was tire balance weights fell off. They were replaced and problem resolved but....the tires were worn irregularly on the inside and I had them replaced.


How Many miles will 2000 Chevy Prizm run for?

it depends on the user.new answerit depends on how good a job the factory did. it can be a lot.


What causes a 2000 Chevy Prizm to die after running for a while when it has a new battery and starts fine?

I had a similar problem with my 2000 Chevy Prizm. It would die intermittently, even when moving. The problem was that the onboard computer (ECM?) has a ground wire attached to the engine. When this wire would come loose the onboard computer would shut the engine off. A mechanic refastened the ground wire to the engine and car has been fine ever since. BTW, I suspect that the previous owner of my Prizm was doing some electrical work and did not reattach the above ground wire properly.