Want this question answered?
High temperature combustion.
Oxidation. At high temperature magnesium ignites - and that is called combustion.
The fuel burning process results in the release of heat that is why the chamber is made of materials that can withstand high temperatures.
Ram B. Gupta and Kayoko Ono. Chemical Engineering, Auburn University, 0322 Haley Center, Auburn, AL 36849-5127Gas and vapor separations using polymer membranes has been brought to focus in the past 20 years. Teflon AF products (DuPont) are amorphous, glassy copolymers consisting of 2,2-bistrifluoromethyl-4,5-difluoro-1,3-dioxole (PDD) and tetrafluoroethylene (TFE). Teflon AF 2400 contains 87 mol % of PDD and 13 % of TFE with Tg = 240 C, whereas Teflon AF 1600 contains 65 mol % of PDD and 35 % of TFE with Tg = 160 C. Teflon AFs have high temperature stability and chemical resistance, as well as high free volume compared to the conventional glassy polymers. Permeability coefficients of CO2 in Teflon AF 2400, Teflon AF 1600, and poly(tetrafluoroethylene) (PTFE) are measured, at varying feed pressure and temperature. The permeability increase in the order of PTFE < Teflon AF 1600 < Teflon AF 2400. This can be explained by the fact that PTFE is a semicrystalline polymer and Teflon AFs are high free volume glassy polymers. In addition, the reuse of the membrane for second and third time resulted in enhancement of the permeability, which can be attributed to the CO2 plasticization of the membrane. Further understanding of the transport of CO2 through the membranes is obtained by applying solution-diffusion model.
There are 2 reasons for using high pressure oxygen in bomb calorimeter. The 1st is that we need enough oxygen for a complete combustion in a very small volume. To do that the oxidant pressure must be high. The typical air ratios in a bomb calorimeter are between 4 and 9. The 2nd reason is that we want to measure the high calorific value of a fuel. Thus the water produced from the combustion must be in liquid form. For a certain temperature, the higher the vapor pressure, the higher the liquid water percentage. So, the higher the total pressure (25 atm), the higher the partial vapor pressure. jimmer
High temperature combustion.
an egr valve opens to put inert gases in the combustion chamber to lower the temperature. this is done to reduce NOx emissions that are produced at high temperatures.
an air conditioning system
N. C. DasGupta has written: 'High temperature combustion'
Because nitrogen is usually very unreactive, it is only commonly found in internal combustion engines (car engines) where the temperature is high enough to make the nitrogen react.
The exhaust temperature of gas turbines is very high due to the large amount of energy input into the inlet air by the combustion of fuel in the combustion chamber.
J. R Herring has written: 'Unusual, high-temperature, iron-rich, mineral phases produced by natural burning of coal seams' -- subject(s): Coal, Combustion, Geology, Slag
whoever asked this is a retard. combustion is a reaction between a fuel and oxygen in the air. during the reaction, the temperature around must be sufficiently high enough to keep up the heat of the combustion. whoever asked this is a retard. combustion is a reaction between a fuel and oxygen in the air. during the reaction, the temperature around must be sufficiently high enough to keep up the heat of the combustion.
Oxidation. At high temperature magnesium ignites - and that is called combustion.
it is produced form animals, plants and factory.
Flash steam is steam that is produced when high temperature high pressure water is released to the atmosphere.
Metamorphic rocks are produced by changing other rocks with temperature and pressure underground.