0
What else can I help you with?
WHAT Is the maximum temperature in gas turbine plant?
The exhaust gases are often up to 500 Degrees C (940 Degrees F) but this can vary wildy depending mainly on load.
How does A bootstrap air cycle machine in an aircraft work?
The air cycle machine (ACM) is driven by turbine engine bleed air that first passes through a primary heat exhanger (much like an intercooler for a turbocharged automotive engine) that significantly lowers the temperature of the 300-500 degree bleed air. After leaving the primary heat exchanger the air flows into a compression turbine that increases the pressure of the air and also increases the temperature. After leaving the compression turbine, the air flows into a secondary heat exchanger that once again lowers the temperature of the air. At this point, the air is at extremely high pressure and relatively low temperature. From the secondary heat exchanger the air flows into the "expansion turbine" where this high pressure air is used to drive a turbine wheel that performs several functions: 1. It extracts energy from the high pressure air, 2. Allows the pressurized air to expand, 3. Drives the compression turbine. The extraction of energy from the air and subsequent expansion of the gases drastically lower the temperatures of the air. In fact, the air temperature is lowered so much that often times hot bleed air is bypassed around the ACM and ducted to the air coming out of the expansion turbine to raise the temperature above freezing. The output air that is coming out of the ACM is then sent through a moisture removal system that essentially uses a fine mesh weave to collect small droplets of water. This removal of moisture helps to control the humidity of the air entering the cabin and it also prevents icing downstream in the system.
What is the temperature inside cylinder of engine at power stroke?
i think the temp inside the cyl during combustion is 500c' to 600c'.
What is the mechanical efficiency of a machine that produce 400 joules of work output from a work input of 500 joules?
The efficiency is 80%. To find the efficiency, 400/500 = 80%.
What steel has a strength of 500 MPa?
Most stainless steels have a strenght of at least 500 MPa. Most alloy steels also have that strength.
WHAT Is the maximum temperature in gas turbine plant?
The exhaust gases are often up to 500 Degrees C (940 Degrees F) but this can vary wildy depending mainly on load.
What is the temperature range of car exhaust?
The temperature range of a car exhaust ranges from 500 to 700 degrees Fahrenheit. An airplane exhaust can reach temperatures of 1200 to 1400 degrees.
What temperature are exhaust manifolds on a running car?
They are 500-1000 degrees F, depending on the engine.
How tall is a wind turbine tower?
The height of a wind turbine tower typically ranges from 200 to 300 feet, although some can be taller. The height is important for maximizing the turbine's exposure to wind at higher speeds, which increases energy production.
Where is the input shaft speed sensor turbine located on a Mercedes cls 500?
Transmission
How hot does car exhaust get?
Car exhaust can reach temps of 500 degrees F. With the hottest points being the exhaust manifolods/headers, and the catalytic converter.
How does A bootstrap air cycle machine in an aircraft work?
The air cycle machine (ACM) is driven by turbine engine bleed air that first passes through a primary heat exhanger (much like an intercooler for a turbocharged automotive engine) that significantly lowers the temperature of the 300-500 degree bleed air. After leaving the primary heat exchanger the air flows into a compression turbine that increases the pressure of the air and also increases the temperature. After leaving the compression turbine, the air flows into a secondary heat exchanger that once again lowers the temperature of the air. At this point, the air is at extremely high pressure and relatively low temperature. From the secondary heat exchanger the air flows into the "expansion turbine" where this high pressure air is used to drive a turbine wheel that performs several functions: 1. It extracts energy from the high pressure air, 2. Allows the pressurized air to expand, 3. Drives the compression turbine. The extraction of energy from the air and subsequent expansion of the gases drastically lower the temperatures of the air. In fact, the air temperature is lowered so much that often times hot bleed air is bypassed around the ACM and ducted to the air coming out of the expansion turbine to raise the temperature above freezing. The output air that is coming out of the ACM is then sent through a moisture removal system that essentially uses a fine mesh weave to collect small droplets of water. This removal of moisture helps to control the humidity of the air entering the cabin and it also prevents icing downstream in the system.
How much oil does a wind turbine consume?
approximately 500 gallons each that must be regularly changed.
What is above or below 500 in baseball?
'.500' refers to a team's winning percentage. 'Below .500' means the team has a winning percentage less than .500 (has lost more games than they have won) and 'above .500' means the team has a winning percentage above .500 (has won more games than they have lost).
What is the exhaust layout for a Mercedes 500sel?
If is anything like the 1984 500 sec; manifold, down pipe, o2 sensor, cat, resonator, exhaust.
How many people does it take to build a wind turbines?
It takes about over 500 people to build a turbine wowza!
How much power can a windturbine make?
1 wind turbine can generate 500 houses per year (kw)
