0
What else can I help you with?
Two switches are 47 meters apart They need to communicate at 600 Mbps What Ethernet physical layer standard should you use?
i would not wanna do your hw
Why you use two switches on PLC for start and stop?
The reason you have to use two switches (a combination of start and stop push button) on PLC is because it is how the program is written.
What happens if two devices have the same priority number?
in STP if both switches use the same default priority, the switch with the lowest MAC address will be the root bridge.
Which portion of the packet does a router use to forward the packet to the destination?
The Destination Address (Layer 2 or Layer 3)
Which part a network layer address does the router use during path determination?
The network address
Sophisticated networks generally use which of the following hardware devices to ease the flow of data packets throughout the network?
Modern networks used two devices for the data packets within the network will flow easily. The two devices are the routers and switches.
Which command is used to checking whether two switches are connected are not?
To check whether two switches are connected, you can use the ping command from the command line interface (CLI) of a device connected to one of the switches. By pinging the IP address of the other switch, you can determine if there is connectivity between them. If the ping is successful, the switches are connected; if it fails, there may be a connectivity issue. Additionally, using commands like show cdp neighbors (for Cisco devices) can provide information about directly connected devices.
Can you say that router is a bridge?
no a bridge does not use a IP address, it uses MAC address', rousters or layer 3 uses ip address.
Which addresses or combination of address es does a layer 3 switch use to make forwarding dicisions?
A Layer 3 switch uses IP addresses to make forwarding decisions. It examines the destination IP address in the packet's header to determine the best path for forwarding. Additionally, it may utilize routing tables, which contain network prefixes and associated next-hop addresses, to efficiently route packets between different subnets. This enables Layer 3 switches to perform both switching and routing functions within a network.
What are the best baking accessories to use for a two layer cake?
The best baking accessories to use for a two layer cake are two baking pans. It sounds simple, but it really is all you need!
What part of the network layer address does the router use during path determination?
routers work at layer 3 (network) which usually means TCP/IP. Routing decisions are made based on a packets DESTINATION IP address.
How do you wire two switches in one box?
To wire two switches in one box, you will need to connect the hot wire from the power source to both switches, then connect the corresponding load wires to each switch. Make sure to properly ground the switches and use wire nuts to secure the connections. It is important to follow the wiring diagram for the specific type of switches you are using to ensure proper installation.
