Any transmission that will fit a gen 1 small block chevy. th200, th350, th400, th2004r, th700r4, muncie 4 speeds, T-10's, etc. As long as you get the right crossmember and driveshaft yolk you've got enough room to fit what you need. Just make sure the bell housing bolts are for a chevy.
NEW ANSWER: The above answer is all wrong. If that truck is a 1/2 ton then it MUST have the 4L60E transmission put back in it. If it is a 3/4 ton then it must have the 4L80E put in it. reason being is because of the computer system and the transmission wiring harness. Yes all the above will bolt up to the engine but the truck will NEVER run right. The ECM / computer will not know what to do.
where is the cranksensor on 1994 chevy pickup with a 6.5 engine
We are going to need to know what engine it has.
where do i put coolant in for 1994 Chevy s10 pickup
The 350 cubic inch (5.7 liter) pickup engine was factory-rated at 200 horsepower in 1994.
Need to know what size engine.
Yes it will
Curb Weight: 4127 lbs std cab 5.0 engine
The recommended spark plug gap for a 1994 Chevy 5.7L Pickup is .035" The recommended spark plug gap for a 1994 Chevy 5.7L Pickup is .035"
There is not any. You MUST put the 4L60E back in it because of the computer system that's on the truck. If you put any other trans. in it then the engine and computer system will NOT work right and you will have all kinds of problems.
hhhhhh
9 to 13 LBS. NO higher and NO lower. MUST be within specs.
9 to 13 LBS. It can NOT be any higher are lower are you will have troubles.