A: A LED is a diode that emit photons when exited with enough current and/or voltage. it does not care where the source come from. for AC IT WILL WORK PROVIDED A SERIES DIODE IS ADDED that is there to prevent the led from burning up when the reverse voltage exceed the saturation current . these devices have a very low reverse voltage breakdown limitation and if they breakdown usually the power dissipation will be exceeded and blow up.
There's no correlation between the voltage, the current, and whether the source is AC or DC.
LED's are DC voltage. Transformers are AC voltage. There is no positive or negative on AC voltage. You would need a diode to change the AC to DC, then there would be positive and negative voltages.
AC !
How do you convert 23 voltage DC to 230 Voltage AC?
Voltage AC was created on 2004-12-14.
AC voltage is varying because it is sinusoidal in nature
This depends on whether the voltage is AC or DC but an oscilloscope is the tool of choice for seeing voltages and how they change with time.
Most of the printers offered in the USA have a voltage of 110V AC input and 8V AC output, whereas the printers offered in the Europe have input voltage of 220V AC and output voltage of 8V AC.
The function of any transformer is to change one AC voltage value to another AC voltage value. A step down transformer will transform a higher AC voltage to a lower AC voltage. A step up transformer will transform a lower AC voltage to a higher AC voltage. The transmission of electrical power uses both of these types of transformers. From the generation station the voltage is stepped up to a very high transmission voltage and at the end of the transmission line it is stepped down to a voltage that consumers can utilize.
A: LEDS are basically a diodes.So yes they can be strung right across the AC line. Unfortunately the reverse voltage is very low and tend to leak at hi voltage. the design should provide protection for the reverse voltage with resistance across each to equalize the leakage current otherwise it will work only once.
For part of the AC voltage wave, the capacitor will be above the source voltage, and will discharge until the AC voltage wave increases above the capacitor's stored voltage.
LED's (Light Emitting Diodes) work on DC current, not AC, so the AC needs to be stepped down to an appropriate voltage via a transformer (probably only a few volts), converted to DC via a rectifier and filter (to smooth out the ripple current). there are a constant driver in side the 120V AC led light bulb , this driver transfer the AC to DC, so the led could work with DC.