MAF(Mass Air Flow) sensor, TPS(Throttle position sensor) sensor, IAF(Intake air flow) sensor, EGR, leaking, loose or missing vacum hoses...
When my 1997 Ford Probe started to do that we toke a look at it and found a few leaks in the Air Intake
AnswerIt has been done a few times, Darryl Stephen's Ford probe packs a 351 Windsor. Anything can be achieved with the right planning, execution and budget.
Turning the steering wheel farthest left or right for a few seconds will cause a loud squealing.
The most common cause of a 1996 Ford Escort to idle rough is bad spark plugs or bad spark plug wires. A plugged air filter will also cause it to idle rough.
none you need a Mazda 4 cylder from a probe mx6 626 there is a few Japanese imports motors that will fit too look up Mazda fe or Mazda f2 motor on wikipieda none you need a Mazda 4 cylder from a probe mx6 626 there is a few Japanese imports motors that will fit too look up Mazda fe or Mazda f2 motor on wikipieda
noAnswerno the only years that will work are 93 to 94 ford probe, 93 to 94 Mazda 626, and 93 to 94 Mazda M6 and if its a (CD4E) Transmission good luck you will need it! Answerthe tranny form a 93-95 should work i swaped my auto out to a 5 speed from a 95 and my car is a 93 works fine few extra parts left over
Check tha idle speed control solonoid.
yes should work fine might be some diff in plugs that you might have to rewire but should have no proble there are few diff between the 93-94
Pretty Fast! I have a few mods but i was up to 135 on the pike the other day. It hauls pretty good. I love the car. I'm on my second one.
No passenger aircraft can be idle in the air. Only a few number of military aircraft can do that. It is called hovering.
why does my C5 corvette idle poorly ,just for a few seconds when coming to a stop?
If both trasmissions are the same model the answer is yes, However, you should check end play because these pumps are not all machined the same. If your end play is to tight it will destroy the pump and other components within a few miles. Having too much end play will cause the same problems, it will just take longer. The washers and shims for the pump come in different thicknesses and this is how you adjust end play.