Want this question answered?
The damper pulley bolt tightening specifications, on a Caterpillar see 15 diesel engine, is 60 pounds per square inch. The pulley should not be tightened beyond 60 pounds.
If you need the torque specs for every single bolt in that whole engine, that is a pretty tall order. Or are you just needing one particular part of the engine, like the head bolts?
There will be a diagram of this in every car's manual. -Follow that specific diagram to order of tightening and torque specs.
Tightening bolt torque
torque c-15 for engine brake
1995 falcon futura 4lt engine torque specs for ALUMINIUM HEAD are ; first, 19 ft lb second,30 ft lb third,plus a 90 deg turn on each bolt. follow tightening sequence. retorque after 500 klm.wait till engine cools. note, specs on gasmiser head gasket.
48 hole bolt tightening seqence
The torque specs for the 1998 Arctic Cat 440 engine are between 6 - 130 n-m depending on the size of the bolt and nut. The ft. per lb specs are between 4.4 and 96 depending on the bolt and nut size.
bolt tightening sequence on what part?
whar are the torque specs for head bolt on a 1999 Mazda protege 1.6 engine
The cylinder head bolt torque specs for a 1972-1979 Toyota 2TC 1600 engine is 64-68 ft lbs.
You have to tighten them three times, first start in the middle and do 25 ft/lbs, then do 50, then do 85 EXCEPT on the number 8 bolt only go to 75. Bolt tightening Sequence (FRONT) 9 8 5 6 1 2 3 4 7 10