Want this question answered?
bike
train
Camels are commonly used as transportation in Egypt.
land transport is used by the traders because markets are on the land.
The transport network was gridlocked.What is your favourite mode of transport?The transport industry is worth billions.
Mostly motorbikes are used in Vietnam
Transport agents are commonly used in email infrastructure. Commonly known as an MTA (Mail Transport Agent), the primary purpose is to transfer email among hosts.
commonly it is a jet plane
Difference between tunnel and transport mode?11 months agoReport Abuserahul_g1...Best Answer - Chosen by VotersIPSec can be run in either tunnel mode or transport mode. Each of these modes has its own particular uses and care should be taken to ensure that the correct one is selected for the solution: •Tunnel mode is most commonly used between gateways, or at an end-station to a gateway, the gateway acting as a proxy for the hosts behind it.•Transport mode is used between end-stations or between an end-station and a gateway, if the gateway is being treated as a host-for example, an encrypted Telnet session from a workstation to a router, in which the router is the actual destination.As Figure 1 shows, basically transport mode should be used for end-to-end sessions and tunnel mode should be used for everything else. (Refer to the figure for the following discussion.)Figure 1 Tunnel and transport modes in IPSec.Figure 1 displays some examples of when to use tunnel versus transport mode:•Tunnel mode is most commonly used to encrypt traffic between secure IPSec gateways, such as between the Cisco router and PIX Firewall (as shown in example A in Figure 1). The IPSec gateways proxy IPSec for the devices behind them, such as Alice's PC and the HR servers in Figure 1. In example A, Alice connects to the HR servers securely through the IPSec tunnel set up between the gateways.•Tunnel mode is also used to connect an end-station running IPSec software, such as the Cisco Secure VPN Client, to an IPSec gateway, as shown in example B.•In example C, tunnel mode is used to set up an IPSec tunnel between the Cisco router and a server running IPSec software. Note that Cisco IOS software and the PIX Firewall sets tunnel mode as the default IPSec mode.•Transport mode is used between end-stations supporting IPSec, or between an end-station and a gateway, if the gateway is being treated as a host. In example D, transport mode is used to set up an encrypted Telnet session from Alice's PC running Cisco Secure VPN Client software to terminate at the PIX Firewall, enabling Alice to remotely configure the PIX Firewall securely
Everywhere, for example sitting on your chair, walking, using a mode of transport.
It depends on the speed of the mode of transport being used.
This cannot be answered without knowing the starting location and the mode of transport used