A circuit is a plan of exercises one does to get fit and a sequential circuit is a set of these one does one after the other, it is called circuit training.
No
A circuit is a complete loop that things can travel around. There are electrical circuits that electrons travel around, and race car circuits around a racetrack, for example.
In Race round condition gate operation delay by signal but gate oprate first with clock ,this condition called the race raund confident
The "Race Around Condition" occurs when J+K=1 i.e. When the FF is in the toggle mode.the race around condition in JK latch can be avoided by:a) Using the edge triggered JK flip flop.b) Using the master slave JK flip flop.
by using master slave flip flop
By using a master-slave J-K FF.
The "Race Around Condition" occurs when J+K=1 i.e. When the FF is in the toggle mode.the race around condition in JK latch can be avoided by:a) Using the edge triggered JK flip flop.b) Using the master slave JK flip flop.
Any race because it is a skin condition
A race condition is an undesirable situation that occurs when a device or system attempts to perform two or more operations at the same time, but because of the nature of the device or system, the operations must be done in the proper sequence in order to be done correctly.
RACE AROUND CONDITION OCCURS WHWN BOTH THE INPUT ARE HIGHAND THE OUTPUT THUS UNDERGOES A TRANSITION STATE.FOR EXAMPLE CONSIDER THE INPUT VALUES IN A JK FLIP FLOP;ie;J=K=1 ,THE OUTPUT Q0=0 IN NORMAL CASE WILL CHANGE TO 1 AND VICE VERSA. THE REMEDY FOR RACE AROUND PROBLEM CAN BE ELIMINATED BY USING A MASTER SLAVE J-K FLIP FLOP'S
The races are usually set up in such a way that it would take approximately 2 hours to finish a race. Based on the track length and lap time, the number of laps are decided. Shorter circuits have more laps while longer circuits have lesser laps.
two or more processes are reading or writing some shared data and the final result depends on who runs precisely when, are called race condition.