Want this question answered?
it's on the firewall beneath the left rad support rod
A bent rod or piston arm.
Its the rod from your front tire to the drive shaft their is one on each front tire
One of the best resources for how-to information is Youtube. Try this link.
Not without removing the head, the pistons can't be lowered past the crankshaft. If you remove the head you can remove the rod bolts at the bottom and push the piston through the top.
The door lock rod in a 1990 wrangler, is assembled with a locking pin on each end of the rod. The locking pins connect the rod to the locking mechanism.
The tie rod torque bolt settings, on your 2000 Jeep grand Cherokee, is 70 pounds per square inch. The bolts should be torqued in 35 pound intervals.
bad or lose tie rod ends or a bent rim
Aftermarket replacement parts will come with grease fittings such as tie rod ends, ball joints, etc.
remove the interior door panel and you can get at the door handle, disconnect the rod and loosen the clips that hold it against the door, the whole assembly will come right out.
The Caterpillar C15 diesel engine torque specifications for the rod bearings is 35 pounds. The main bearing torque specifications is 350 pounds.
The Caterpillar C15 diesel engine torque specifications for the rod bearings is 35 pounds. The main bearing torque specifications is 350 pounds.