0
What are the advantages and disadvantages of replcing Karachi with islamabad as the capital of Pakistan?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is eyes transplantation?
Eye Transplantation is the technique of replcing eyes of one Person to Another person.
1989 Ford Ranger XLT 2.9 V6 - after replcing the head gasket the battery voltage gauge does not work - what do you look for and where Thanks Phil?
looking from the front of the vehicle, the left head has a spot on the back that a ground feed connects. make sure that this was reinstalled
What causes transmission to hesitate when you give it gas after replcing transmission?
Stick or auto? with a stick, the motor hesitates if any thing. with an automatic, check your fluid level, the color of it should be a redish pink. don't overefill. If color is sortof black or brown then change fluid and filter for tranny.
Figure the volume if an object has a density of 0.5 grams per cubic cm and a mass of 80 grams?
By calculation, it's160 cubic cm procedure:density= mass/volume. by replcing the proper values in z proper places u get z answer...u may convert in SI units also....:)
Ive changed the water pump and the hoses on your 1995 Nissan altima but didnt put antifreeze in it only water could the water evaporate and cause the car to run hot?
I have only water on my Nissa Altima and the water does not evaporate. It would be a good idea to replace the thermostat. I was having problems with my car overheathing and replcing the thermostat fixed the problem.
Why would a 2002 escape turn off 2 seconds after turning it on?
it could be a couple of small things ,,,,, i would check the oil knock senser i had a very dificult time with one of these. i wound up replcing most of the other sensers ,map ,tpi, iac . dont be afaid to unplug things and always ceck to see if it has oil ,, water and that its getting fule and clean air. i hope this info helps
Why does blower not blow on 1 or 2 does blow on 3 and 4 Ac comp kicks in on 1 or 2 but does not on 3 or 4?
Defective Resistor Pack. Can you tell us where this is located? Their was a recall on the blower relay that I was able to get a free replacement one for my 90' 626 from the dealer a long time ago . My only problems is that the relay has gone again and they wont cover it because the first one is on file that it was replaced for free. Check with the dealer and see if the recall is still valid .......its worth a phone call .........eh ? Yes it's the relays under the glove box.The problem will keep coming back UNLESS you open the hood and look at the weep holes on both sides of the wiper gutter.The one over the relays gets plugged up causing water to flow into the relays.Clean those weep holes out every oce in a while and after replcing the ones you have (expensive in my book) you should not have a problem again.
Reproduction where there is only one parent?
It is called asexual reproduction. Asexual reproduction is common with certain plants, like strawberries. Cloning also involves one parent. What happens is they find a female animal that is the same breed as the animal. Then they remove the egg, take out its nucleus replcing it with th nuclus of the cell of the animal they are cloning, and replant the egg back into its animal the egg came from. Then when the animal is born, it has no resemblance to its mother, but looks similar to the animal cloned. I hoped i helped.
How do you change oil in a 2000 passat V6?
Open drivers door. Get in. Drive to dealership and pay them $300 for the same service that would cost $30 on a Ford. Sell POS car because if you haven't strarted replcing $600 oilpans you will soon. Open the engine compartment and unscrew the oil filler cap located on the right side of the motor near the top. Next, you proably will need to jack the front of the car up a bit in order to get under it for the following procedure: Remove the under-carriage cowling by unscrewing the 7 connectors (only a half turn on each screw will release the cowling). Locate the oil drain plug which is conveniently located at the side of the pan for easy removal (it faces the driver's side front wheel nearly in line with the axle). Place the oil pan beneath the plug and unscrew the plug using either a socket or open end wrench. Once the oil is drained, loosen the oil filer counter-clockwise (which is located close the plug). Allow the excess oil to drain completely from both areas. Once the oil has been fully drained, clean the surface area where the new oil filter will be attached. Make sure you put a small bead of fresh oil on the surface of the gasket so it will seal when screwing it back on in a clockwise direction. Only hand-tighten the oil filter following the directions on the filter (usually one full turn past the initial point of resistance--it should be very snug--but with no power tools or the aid of a wrench of any kind). Then, screw in the cleaned plug for the oil pan--using a wrench and tigthening it up real snug--but not so tight that it strips the threads. Add the new oil (5-30weight) carefully so as not to spill any in the engine compartment. It will take about 6.5 quarts--be careful not to put in too much--do not go past the "max" line on the dip-stick. Once all the oil is in, close the cap, be sure the dip stick is seated and start the motor--checking to make sure there are no leaks at the plug or the new filter. Turn off engine and re-attach the under-carriage cowling. That's it!
