Typical bulb holders are made of brass coated with ceramic.
Open the trunk and on the side you will see a clip, unscrew the 'clip' and pull the fabric down gently. This will expose the tail light bulb holders. Turn the light bulb holders until they come out, about 1/2 turn. remove bulb and replace.
The turn signal bulb? It's done from inside the trunk. Pull the carpet away from the backside of the taillight assembly. The bulb holders just twist out. Replace the bulb, re-seat the bulb holder and put the carpeting back.
reds people
peel off carpeting behind the tail light from the trunk. there should be bulb holders- pull out the holder that holds the busted bulb. you can do this by slightly turning it and pulling it out. change the bulb and replace the holder the same way you removed it.
If you have tiny hands you can reach up and twist the bulb holders out to replace the tiny bulbs
remove the battery(drivers side) or coolant reservoir(passanger side) to see the bulb holders twist and pull to reveal the bulbs
lift hood,on top of the headlights are tabs to pull up.pull the tabs up and pull the headlight towards you and it will make the bulb holders visible
You need to raise the liftgate, then remove the liftgate upper trim panel. Remove the panel by carefully pulling straight out, it's only held in by spring clips. You'll now be able to access the bulb holders. Remove the bulb holders by rotating them 1/4 turn clockwise. The bulbs pull straight out from the holders. Put everything back together in reverse.
Fused bulb
a bulb
water boys