the Haynes manual says cylinder head bolts are 80 ft-lbs
No, it is not an interference engine.
I have a 94 Plymouth sundance duster. I am sure the location is the same. It should be right behind your oil filter underneath the engine. If you jack the front end up and slide underneath, you should see it behind the oil filer. If yo have the six cylinder the above is true. If you have a four cylinder the starter is under the manifolds on the rear of the engine.
Depends on the engine
Inside the engine computer.
The engine computer is the regulator.
It is screwed into the exhaust manifold on the rear of the engine.
cycle the key three times and count the blinks of the check engine light
Probably a bad head gasket.
1 - 3 - 4 - 2 The distributor rotor turns CLOCKWISE The marked # 1 position on the distributor cap faces towards the engine / # 1 cylinder According to my Chilton book
as you face the engine look on the right side of the trans. housing, there should be a pc. of black foam rubber stuffed into a slot pull that out and you will see the timing scale.
What are cylinder head bolts torque settings for Isuzu kb240. Engine NAQ001716
It would greatly help to know what engine you have and if it has air conditioning (working or not)