0
What are the flywheel bolt torque specs for a 1967 Pontiac 400?
Wiki User
∙ 14y ago
Torque to 95 foot pounds with thread locking compound.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the torque specs for 1967 Pontiac 400 rod bearings?
45 foot pounds for regular connecting rods and 65 foot pounds for SD connecting rods.
What are the 1967 Pontiac gto alignment specs?
Go to the library and look that up in a chiltons repair manual for your year car.
Will a 67 Camaro flywheel work on a 67 lemans?
If you are asking if a small block chevy V8 flywheel (most common engine in a 1967 Camaro) will work on a Pontiac V8 (most common engine in a lemans), the answer is no.
What are the torque specs for 1967 Ford Mustang 6 cylinder exhaust manifold?
The only reference my manual has to exhaust manifold bolts says to tighten them and bend the locking tabs over.
When was Pontiac Firebird created?
Pontiac Firebird was created in 1967.
In a race what would win a 1967 Pontiac GTO or a ford GT?
1967 Pontiac GTO cuz it has a bigger Motor in it.
When did Pontiac firebird begin?
1967 was the first year for the Pontiac Firebird.
What has to be done to switch a automatic to manual trans in a 1967 mustang?
Lots of work. Check that the crankshaft to torque converter/ flywheel boss are the same and there is centre bearing for the input shaft. Check auto/manual rear axle ratio the same. Change torque converter for flywheel and clutch assembly, bell housing, gearbox, propshaft and, as necessary, rear axle. Install different pedal carrier and pedals, install clutch linkage
What year did Pontiac began production?
1967
Is 1969 Pontiac 400 water pump compatible with 1967 Pontiac 400?
yes
How many 1967 Pontiac gto made?
Total production for 1967 was 81,722 units.
What size engine in your 1967 catalina?
389 and a 421 engine for a 1967 Pontiac catalina
