Want this question answered?
Audio output frequency is that range of frequencies that can be heard. For humans, that is generally considered to be the range of 20Hz to 20kHz.
3MHz
The frequency would decrease the gain and increase the output voltage
A mixer is a non-linear circuit that multiplies two signals together. If the inputs are sinewaves at frequencies f1 and f2 the output will contain signals at four different frequencies, f1, f2, f1 + f2, and f1 - f2. Some mixers may eliminate some of those outputs and post filtering can remove any other unwanted components. This is the way AM and SSB are typically generated. Modulation is a more general concept, and depending on the type of modulation you are doing, a mixer may or may not be involved in the modulation process.
Quite simply, it's an amplifier wherein the stages as set up so that the output of one stage is coupled directly into the input of the next stage without any wave shaping or tuninig components between them. This makes for fairly flat frequency response. A link is provided to the Wikipedia article on direct coupling.
The frequency determining components in a phase shift oscillator are the series of resistive/capacitive filters on the output of the inverting amplifier. See accompanying link.
You can't do this unless you know more detail on the frequency modulator, like its modulation index, for example or the frequency deviation. For the amplitude modulator, it is easy. Bandwidth is twice the signal frequency so in this case the bandwidth is 178kHz for AM.
the output from a balanced modulator consists of modulating freq also. this can be eliminated in a diode modulator by adding two more diodes, making a diode ring. therefore called ring modulator
the output from a balanced modulator consists of modulating freq also. this can be eliminated in a diode modulator by adding two more diodes, making a diode ring. therefore called ring modulator
An input output device that modulates and demodulates is a modem.
ETW-5000
ufm = Universal Frequency Modulator / Universal Flow Monitor
twice the input frequency
You need to describe symptoms. Check oscillator frequency and power supply.
A tank circuit is used on a radio transmitter. It is an electronic circuit that is used to tune a specific frequency. The tank is made up of two components, an inductor and a capacitor. The two components are connected in a parallel with each other. This is where the term "tank" comes from. Used in a radio transmitter, it is tuned for maximum RF (radio frequency) output on the frequency the transmitter is tuned to.
Not generally no. There would be no point. The easiest is to convert the standard yellow video out to coax with an RF modulator
Audio output frequency is that range of frequencies that can be heard. For humans, that is generally considered to be the range of 20Hz to 20kHz.