look in te manual :-)
they are all torque 20nm/15lbf ft then after all angle tightened 260 degrees
in sequence torque bolts to 20nm, then again in sequence turn a futher 120 degrees, and again in sequence 120 degrees.
The torque settings for aluminum head are; stage 1. 15lb ft. Stage 2 you have to set the correct torque level by angular measurement, angle tighten a further 240 degrees. Cylinder head tightening sequence is important if you do not want to warp the head. Get down to your local library go to the technical section and photocopy the section from the Haynes manual
citroen saxo 1.4. what is the rear brake hub torque setting?
inlet 20 exahust 40
just open the bolt on the sump and oil should drain
saxo is good, saxo is reliable..
To find more information about Forex trading, contact Saxo Bank. They can reached by phone, fax and email in either Dubai or the head office in Danmark.
depends on which MG and which SAXO???
All saxo and 106 gearboxes are interchangable.
Saxo Bank was created in 1992.