iat sensor is not part of mass air on a rx7. the iat sensor is located on drivers side of engine below bypass air valve.near oil fill cap. two wire connector
Yes. It has an O2 sensor on the exhaust y-pipe.
under the termostat housing.
O2 sensors are located in the manifolds & front pipes
on my 1986 turbo, it was just past the firewall on the drivers side. if you follow the exhaust back from the engine you will find it. 2 wires looks kinda like a spark plug. o'reilly has adaptors to remove the o2 sensors. buy or leave a deposit on it.
Most oxygen sensors are located on the exhaust manifold or just after the manifold on the exhaust pipe(s). Your truck probably has two oxygen sensors, one on each side.
On the 1986 Mazda B2000, the temperature sensor is typically located near the thermostat housing on the engine. It can usually be found screwed into the engine block or cylinder head, where it measures the coolant temperature. For precise identification, consult the vehicle's service manual or look for a single-wire connector leading to the sensor.
The 1986 Pontiac Fiero does not have an air mass sensor, as it was not equipped with one during that model year. Instead, it uses a speed-density fuel management system that relies on a manifold absolute pressure (MAP) sensor to determine air intake. This approach was common in many vehicles of that era. Later models may have incorporated more advanced sensors, but the 1986 version does not include an air mass sensor.
The fan switch, on your 1986 Chevy, is located on the fan of. The switch will have three wires going to it, from the temperature sensor.
The connections for the sensors? or where the sensors connect to the computer? If the sensors plugs are what you are after, then the rear sensor plugs are in the trunk, under the carpet (that where they are on mine). The front sensors are on top of the strut towers under the hood. If you are talking about where the sensors plug into the computer at, the computer is located right next to the brake booster itself. If you have a ABS light on, and the pump runs for the system runs to much, I suggest replacing the accumlator. You can get them at the GM dealer or from Prior Manufacturing.
The engine oil capacity for a 1986 Mazda B2000 is 4.1 quarts.
They were not used in 1986
There is no crank sensor on a 1986 camaro z28.. that sensor is in the camaros past 1988 i believe.. but the 1986 carb or fuel injection (tpi) does not have one