0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is lozenge joint?
A riveted joint known as Lozengejoint used for roof, bridge work or girdersetc. In such a joint,*diamond riveting is employed so that thejoint is made of uniform strength.
Failure of knuckle joint?
rod tensile failure
What does the acronym DFMEA stand for?
The acronym DFMEA stands for "Design Failure Mode Effects Analysis". DFMEA is an extension of Failure Mode and Effects Analysis which attempts to estimate the frequency and severity of each failure mode.
Why is caulking and fullering is done on riveted joints?
Caulking :TO make metal to metal contact Fullering :To have rivet to part contact.
How does electro hydraulic governor functions?
governor has 3 modes of operation 1.SPEED CONTROL MODE-before sychronisation the governor runs in speed control mode.guide vanes open up and the turbine runs in the rated speed.when the governor gets connected to the grid that is when it gets synchronised then the speed control mode terminates. 2.OPENING MODE-load is increased in this mode and teh machine runs in the rated speed only. 3.POWER CONTROL MODE-it has two modes.joint controller and indivisual controller mode.in joint controller mode all the machine works all together and in the indivisual controller one setup point is given to the governor and the guide vanes vary accordingly
What is the efficiency of riveted joint?
The efficiency of riveted joints is the ratio between the minimum strength of the joint against failure by tension, shear or bearing to that of the members without a joint .balamurugan.g
What is lozenge joint?
A riveted joint known as Lozengejoint used for roof, bridge work or girdersetc. In such a joint,*diamond riveting is employed so that thejoint is made of uniform strength.
Failure of knuckle joint?
rod tensile failure
What does the acronym DFMEA stand for?
The acronym DFMEA stands for "Design Failure Mode Effects Analysis". DFMEA is an extension of Failure Mode and Effects Analysis which attempts to estimate the frequency and severity of each failure mode.
Mode of failure of riveted joints?
1)Tearing of the plates between the hole if they are very near to each other 2)Tearing of plate betw.een the edge of the plate and rivet hole if the hole is too near the edge. 3)Shearing the rivet if the diameter is smaller than necessary
Displacement of a bone out of the socket is?
joint failure
How do you change a upper passanger side ball joint on a 1994 Chevy silvarado 4x4?
if it is original the upper ball joint is riveted in, it will need to be chisel out,there are four rivets and then the nut that holds it to the control arm.new ball joint will come with bolts and nuts
Use riveted in a sentence?
I was riveted to my father's agony.
What does the Ford Ranger error message fmem mode refer to?
FMEM - Failure Mode Effects Management ( limp in for repair mode )
What is the definion of adhesive failure?
When the glue joint comes apart.
How do you fix 1998 chrysler lxi limp mode?
The first step is to check the vehicle for trouble codes. That will tell you what failure the computer saw when it defaulted to limp mode. You can then diagnose and repair the failure.The first step is to check the vehicle for trouble codes. That will tell you what failure the computer saw when it defaulted to limp mode. You can then diagnose and repair the failure.
How do you produce a good hot or cold riveted joint and how would you use the various riveting tools?
ive got this stupid question in my level 3 too lol
