0
What else can I help you with?
What are all the parts of a pulley?
a pulley is a wheel with a groove along with a rope or chain.
What are the three parts of a pulley?
The three parts of a pulley are the wheel, the axle, and the rope or cable that runs over the wheel. The wheel is the round disc that rotates on the axle, the axle is the central rod that the wheel spins on, and the rope or cable is what is pulled to move objects.
Power steering pump pulley?
It takes a special tool to remove the pulley and install the pulley. The tool can be rented from your local auto parts store.
How do you remove power steering pulley 2005 impala?
To remove that pulley with out damaging the pump or the pulley you need a power steering pulley puller. This tool will also install the pulley. Your local auto parts store can rent or sell you that puller.
Ac bypass pulley on 1989 Chevy?
An ac bypass pulley for a 1989 Chevrolet can be purchased at any auto parts store. The cost for the pulley starts at $26.04.
How does the power steering pulley come off a ford ranger?
The pulley needs to be removed before you can extract the pump, you can get the pulley removal tool at a car parts store.
How do you change a bad bearing in a pulley?
In most cases you can purchase the bearing and pulley as an assembly from your local auto parts store.
How do you get the power steering pulley off a 1999 suburban?
It requires a power steering pulley PULLER. You can rent them at some parts stores.
What parts might make a pulley?
A wheel, a groove and a rope/chain.
How do you remove the power steering pulley from a 1996 Pontiac Bonneville?
There is a specific tool for this operation. It is a power steering pump pulley puller. This grabs the groove in the end of the pulley and pushes the punp shaft away from the pulley. Available at your parts store.
Which of the following is not a compound machine pulley bicycle?
The bicycle is not a simple machine, there are too many interacting moving parts.
What is a idle pulley?
idle pulley is a pulley on an engine that does not drive any accesories ,such as water pump or alternator. it is put there to route the belt so as the belt will not hit or rub on other parts or accesories
