answersLogoWhite

0

The plug in pins on most processors are made of gold plated aluminum.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How manyNumber of pins are present in 8086 microprocessor?

The 8086 microprocessor has 40 pins.


Can you change the pins in 8085 microprocessor?

No. The pins are preset by Intel.


How do you tell which power plug you have?

Well, if it has 2 male pins, then it is a EU (European) plug. If it has 3 male pins, it is a UK plug.


What is the function of pin's1 and 20 in 8086 microprocessor?

Pins 1 and 20 in the 8086 microprocessor are (both) power and signal ground (GND).


What is pin configuration of microprocessor 8088?

the pin configuration of a processor means that the diagramatic representation of block diagram of processor representing various pins and the function of that pins


Why 2 gnd are used in microprocessor 8086?

Two ground pins are used in the 8086 microprocessor to increase the bus pull-down current capacity.


What are the different kinds of microprocessor?

Mainly there are 2 types of microprocessors :- 1.Pinable (that contains pins ). 2.Pinless (that doesn't contains pins )


How many pins are present in 8085 and 8086 microprocessor?

There are 256 ports available in the 8085 microprocessor. The IN and OUT instructions have an 8-bit port number, and that is where the 256 comes from.In order to use ports, the hardware addressing system must decode IO/M-. Some implementations don't do this, so they map IO addresses to memory addresses. In that case, you could say there are 65536 possible IO addresses, but that is not the same as ports, because ports are specific to the IN and OUT instructions.The other "problem" with IN and OUT is that you cannot specify the address in a register, while you can do so with indirect memory addressing.


Can you plug a dryer into an electric range plug?

Not normally, the pins are in a different configuration.


What is microprocesser 8085?

microprocessor 8085 is basic 8 bit microprocessor by Intel Corp. it has 64Kb memory and 16 address buses and 8 data buses it has 40 pin ic. 8 address and 8 data buses are multiplexed with each other for reducing the total number of pins from the microprocessor 8085 . it require 5MHz clock frequency for operation. only a crystal which connected easily across two pins of microprocessor can provide this clock.


Why there ground pins on a microprocessor chip?

There are ground pins on a microprocessor chip for the same reason there are ground pins on any kind of chip - to provide a current sink path for gates that need to pull to ground. If you are asking why there are two ground pins on some processors such as the 8086/8088, the answer is that one ground pin is not enough - that if all gates pulled to ground at the same time, the current transient would destabilize the processor - so two were provided.


What is the Japan plug type and is it the same as the plug type used in the US?

The plug type used in Japan is Type A, which has two flat parallel pins. This is different from the plug type used in the US, which is Type A or Type B, with two flat parallel pins or two flat parallel pins and a round grounding pin, respectively.