Want this question answered?
I don't have 2000 specs, but according to the 2004 Sienna Repair Manual the torque spec for the front brake caliper mounting bolts is 79 ft-lbs and the torque spec for the brake pad pins is 25 ft-lbs.
Brake caliper bolts torque is 90ft-lbs. Wheel Lug Nut torque is 83ft-lbs. Brake caliper bolts torque is 90ft-lbs. Wheel Lug Nut torque is 83ft-lbs.
70
You will need to bleed the brakes, starting from the caliper furthese from the master cylinder then moving closer.
Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Next, put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.
How can you manually release the emergency brake on the 1998 Toyota Sienna?
Torque specs for brake caliper bolts 2005 mazda 6
Lift the vehicle, remove the tire and set it aside, remove the brake shoe/caliper, and remove the old brake pad. Throw away the old pad, put in a new brake pad, replace the brake shoe/caliper, replace the tire, tighten the nuts, and lower the vehicle.
For the Chevrolet S-10 model years from 1982 to 1993, the torque for the caliper mounting bolts is 37 ft. lbs. The torque setting for the brake hose-to-caliper bolt is 32 ft. lbs.
Front caliper mounting bracket bolts torque to 57ft-lbs Front caliper pin bolts torque to 27ft.lbs Rear Caliper mounting bracket bolts torque to 38ft-lbs Rear caliper pins torque to 15ft-lbs
20-25lbs.
The Toyota Sienna should have high and low marks on the side of the brake fluid reservoir. Check to see that the fluid level is between the two marks.