For the Chevrolet S-10 model years from 1982 to 1993, the torque for the caliper mounting bolts is 37 ft. lbs. The torque setting for the brake hose-to-caliper bolt is 32 ft. lbs.
torque specifications
Front caliper mounting bracket bolts torque to 57ft-lbs Front caliper pin bolts torque to 27ft.lbs Rear Caliper mounting bracket bolts torque to 38ft-lbs Rear caliper pins torque to 15ft-lbs
Brake caliper bolts torque is 90ft-lbs. Wheel Lug Nut torque is 83ft-lbs. Brake caliper bolts torque is 90ft-lbs. Wheel Lug Nut torque is 83ft-lbs.
Torque specs for brake caliper bolts 2005 mazda 6
_________________________________________Front caliper bracket mounting bolt-148 ft-lb Front caliper guide pin bolt-74 ft-lb
The Chevrolet 2.2 liter engine had bolt torque specification is 120 pounds. The head bolts should be torqued in 40 pound intervals.
Tighten Caliper bolts to 25 Ft. Lbs.
The head bolt torque specifications for the 1986 Chevrolet Corvette is 200 pounds per square inch. The bolts should be torqued at 50 pound intervals.
not sure from your question which caliper bolts you mean. the caliper to mounting braket bolt is 63 foot-pounds (these are the two bolts per caliper that you remove to change the pads. They are a pin and pass through a rubber boot). caliper mounting bracket to suspension is 137 foot-pounds (these are the two bolts per bracket that you also remove if you are changing the rotor disk). the factory uses red loctite on them and they are a bear to get out.
Front caliper bolts 25 ft/lb Mounting bracket bolts 80ft/lb
32ftlbs for the pin bolts
The torque settings for the caliper pins on a Ford Escort is 21 ft-lbs. For the caliper anchor bolts, the setting is 98 ft-lbs.