Want this question answered?
cegab
Young Mr. Bobbin was created on 1951-08-29.
The bobbin is wound in the bobbin case. You open up the slide plate and push the little lever with the bull's eye on it all the way to the left. Then you thread the needle with the thread you want on the bobbin, then pull a few inches and wrap the needle thread around the knurled knob that holds the foot onto the shaft (to keep it from slipping.) Then you push down on the foot pedal and the bobbin fills from the needle thread. Don't overfill the bobbin or it won't wind out properly.
gabc(or short c)cbagfge
You could try the link below. :)
There is a lot of ways.....you can search them up. For example you can searh them up in Google
look it up the notes if you dont know them and if not call a music teacher
I'm assuming you're talking about winding a bobbin on a sewing machine? If so, there is a post similar to the one for thread (near it) that you put the empty bobbin on. Then you put your spool of thread where it goes on the machine. You wind your thread from the spool of thread to the bobbin (there's usually a little chart on your machine, but if not, the thread goes through a hook or two and then you wind it about 4 times around the bobbin (clockwise). In newer machines you then push the bobbin toward a holder type thing that is near it. This disengages the needle from going up and down and lets the machine wind the thread as you push the pedal. On older machines, you have to turn the handle of the machine toward you and it disengages the needle, allowing the bobbin to be filled when you press the pedal. Hope this helps! You could probably google your sewing machine name and how to thread a bobbin and maybe get a diagram.
if you have just started playing the recorder I suggest that you begin by memorizing the notes then learning to read sheet music then paying songs. if your already good at playing the recorder try searching up: Mary did you know, recorder quartet on Musescore.
Depends on the machine brand. To determine which way to load the bobbin into the bobbin case you need to determine which way the slot is facing that the tread slides into prior to it slipping under the tension clip. Hold the bobbin case with the opening away from you with the slot facing up. If the slot on the bobbin case is facing to the left put the bobbin into the case with the thread spinning the bobbin counter clockwise. If the slot on the bobbin case faces to the right put the bobbin into the case with the thread spinning the bobbin clockwise.
b b b a g a b g a d e
Any song just have fun and look up on youtube or rite here the notes to that song