Ask This Old House - 2002 Installing Mantel and Hearth Rejuvenating Baseboard Radiator 8-14 was released on:
USA: January 2010
Ask This Old House - 2002 Choosing Groundcover Installing Hydronic Baseboard Heaters 9-6 was released on: USA: 13 November 2010
To remove baseboards without causing damage, use a putty knife or pry bar to gently loosen the baseboard from the wall. Slide the tool along the top edge of the baseboard to release it from the wall. Be careful not to apply too much force, as this can cause the baseboard to crack or break. Once the baseboard is loose, carefully pull it away from the wall. If necessary, use a small piece of wood to protect the wall while prying the baseboard off.
Well the temperature of the cars engine could rise after you change the radiator if you did not put in enough water. Is the radiator the correct one for the car? Did you make sure all the waterways were clear before installing? Failing that, you could have an air lock in the system, release the hoses and top up water until it flows clean. The thermostat may be jammed shut, or blocked with debris.
Ask This Old House - 2002 Removing Overgrown Shrubs Quieting a Noisy Baseboard Heater 10-6 was released on: USA: 12 November 2011
A baseboard heater runs through a process of induction and release, in a manner of speaking. That is, the burner will heat the water; the water will pump through the system; and once all is up to temperature, the burner will shut down. However, the metal of the pipes and the water itself will not cool right away; it will remain hot for a time and cool slowly. The closer the baseboard is to the furnace itself, the longer it will remain hot.
On the radiator, bottom, passenger side, facing the firewall. Turn it counter clockwise to release.
Ask This Old House - 2002 Installing a Ceiling Fan Installing a Water Softener 11-12 was released on: USA: 22 December 2012
To fix bleeding baseboard heaters in your home, you can try bleeding the air out of the system by using a radiator key to open the bleed valve on each heater. This will release any trapped air and allow hot water to flow properly, reducing or stopping the bleeding. Make sure to turn off the heating system before attempting this and have a towel or container ready to catch any water that may come out. If bleeding the heaters does not solve the issue, you may need to check for leaks or other problems in the system that require professional assistance.
The purpose of the air valve in a steam radiator system is to release trapped air from the system, allowing steam to flow freely and efficiently heat the radiator.
No, there should not be pressure in the radiator after cooling down. If there is still pressure, it could indicate a problem with the radiator cap or the cooling system, such as a leak or a failing pressure release valve.
Ask This Old House - 2002 Installing New Vinyl Trim Installing a New Dishwasher 10-20 was released on: USA: 18 February 2012
MuscleCar - 2001 Olds Radiator Mount and Exhaust was released on: USA: November 2013