Typically pine is used because it is inexpensive. Typically it is utility grade but a nicer grade is easier to plumb
My area, 2 3/8" is pretty standard.
A wooden door is wood. and a sleel door is steel
Should be printed on inside of driver door frame. This is standard location for most.
There is no standard door width as they come in 2" increments up to 36" wide. A common door jamb width is 4-9/16" width, this is for a 2x4 wall and 1/2" drywall on both sides.
A door frame is the rough opening that the door and door jam go in to. Door frames are part of the framing of a house and the door jam is the out side frame that the door sits in.
I did it and the result is not too bad...it will not keep thieves out of my home but they wiil make a lot of noise to get into my house..
A standard solid core door installed in a frame with no sound seals or door bottom seal will achieve an STC rating in the lower 20's.
it depends if you have a wooden door or a glass door. if you have a wooden door, then you can't do much about it, but if you have a glass door, then just install double glazed windows.
36 inches is the standard doorknob height.
14'x14'
One part of a door frame is the molding, which is the area cut out to hold the door. The frame is the wood or steel placed inside the molding to bolster the strength of the door. The casing is the part of the door inside the frame that insulates. The hinge holds the door on and the contact plate is the area cut out to hold the bolt part of the lock.
There is no standard door width as they come in 2" increments up to 36" wide. A common door jamb width is 4-9/16" width, this is for a 2x4 wall and 1/2" drywall on both sides.