What are the steps for changing the Back brakes for 2005 jeep liberty?

Answer 1

# Raise and support vehicle. # Remove the wheel and tire assemblies. # Compress the caliper # Remove the caliper slide pin bolts NOTE: Do not allow brake hose to support caliper assembly. # Remove the caliper by tilting the top up and off the caliper adapter # Support and hang the caliper. # Remove the inboard brake pad (1) from the caliper # Remove the outboard brake pad (2) from the caliper # Place an old brake shoe between a C-clamp and caliper piston. Bottom piston in the caliper bore with C-clamp. # Clean caliper mounting adapter and anti-rattle spring guide # Lubricate anti-rattle spring guides with Mopar brake grease. # Install anti-rattle spring guides NOTE:Anti-rattle spring guides are not interchangeable. # Install inboard brake pad to the caliper # Install outboard brake pad to the caliper # Tilt the top of the caliper over rotor and under adapter. Then push the bottom of the caliper down onto the adapter # Install caliper to the rotor and then install the caliper slide pin bolts, Install wheel and tire assemblies and lower vehicle, # Apply brakes several times to seat caliper pistons and brake shoes and obtain firm pedal. # Top off master cylinder fluid level.