Disconnect the negative battery cable. Properly drain the transaxle. Remove the air intake duct. Disconnect the TV cable. Remove the shift cable and bracket. Tag and detach all necessary vacuum lines and electrical connections. Remove the Power Steering pump and set aside. Remove the transaxle filler tube. Install engine support fixture J 28467-A or equivalent. Remove the top engine-to-transaxle bolts. Raise and safely support the vehicle. Remove both front tire and wheel assemblies. Remove the left splash shield. Remove both front ABS wheel speed sensors and the harness from the left suspension support. remove both lower ball joints. Disconnect the stabilizer shaft links. Remove the front air deflector. Remove the left suspension support and both drive axles. Disconnect the engine-to-transaxle brace, then remove the transaxle converter cover. Remove the starter Unfasten the flywheel-to-torque converter bolts. Disconnect the transaxle cooler pipes. Detach the ground wires from the engine-to-transaxle bolt. Remove the cooler pipe brace and the exhaust brace. Remove the bolts from the engine and transaxle mount. Support the transaxle with a suitable jack. Unfasten the transaxle mount-to-body bolts. Remove the heater core hose pipe brace-to-transaxle nut and bolt. Unfasten the remaining engine-to-transaxle bolts, then remove the transaxle assembly from the vehicle.
There are way too many steps involved to this procedure to post a response in this forum. Do yourself a favour and buy a chiltons or haynes manual for about $20.
This is a big job. You're going to want a shop manual that gives you all the required steps and photos. Haynes or Chilton will probably do just fine.
Sunfire fuel pumps are located inside the fuel tank. Replacing them requires the draining and removal of the fuel tank. If you're undertaking this job yourself, definitely pick up a Haynes or Chilton manual for your car. This will give you all of the steps with photos.
It's hard to be specific here. Go to your local parts store and pick up a Chilton or Haynes manual for your car. Either one will have very good directions with pictures.
There are kits available for fixing fiberglass steps that are pulling away from the pool. You will need to drain the water below the area where you will be working.
The fuel pressure gauge will help you check the fuel pressure in a 1997 Sunfire. When the pressure is low their is a repair manual which advises on what steps to take.
No, you do not have to remove the battery. Just remove the 2 bolts (1/2 socket) on the top and pull out the whole assembly. Then undo the big plastic nut and remove bulb and redo steps to install.
Go buy a manual from your local parts store. Like most auto repairs, it involves multiple detailed steps. Read up on what you need to do, and which tools you'll require. After that, decide whether you have the skills, time, and tools to undertake it.
it is on the left hand side of the radiator facing the road ahead of the car. when you are looking at the little 3/4" round fitting that has a blade across it.... rotate it one quarter turn counter clockwise, the pull towards you. the initial twist unlocks the petcock, and pulling it lets loose the coolant, so be ready.
If u have carpet lining in the trunk like I do then when u open the trunk pull the liner behind the bulb u want to replace and the bulb socket should be there...twisting the bulb counter clockwise an eighth of a turn should pull it loose, pull the socket out and replace the bulb then put it back in and follow the previous steps in reverse
This is pretty involved. DO pick up a Haynes or Chilton manual before starting. You really need to be able to check all the details and procedures. FriPilot
The steps to take for using an extinguisher for a Class A fire include pulling the pin, aiming low on the fire, squeezing the trigger, and sweeping from side to side across the fire.