answersLogoWhite

0


Best Answer

Spoken like a person who doesnt own a 2000 Hyundai Sonata. Don't you know there is a dearth of auto manuals for this particular model? Instead of just writing a flippant answer maybe stop to consider why someone might be inquiring.

Answerbuy a manual
User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are the steps to replace a radiator in a 2000 Hyundai Sonata?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What steps do you take to replace the radiator in a 1991 Sunbird?

call birdman


What are the steps to install a towel radiator?

The steps that are necessary to install a towel radiator vary depending on the model of the radiator and the space that you're looking to install it in. For the most accurate instructions, consult the instruction manual for your particular radiator, or contact the radiator's manufacturer.


How do you install a radiator 2000 mercury mystique 2.0 liter engine?

There are 11 steps on how to change a radiator in a 2000 Mercury Mystique 2.0 liter engine. Some of the step-by-step instructions are to first squeeze the hoses to check for deterioration, if the hoses are swollen replace them, and then replace the hose clamps.


How do you replace a radiator on a 1986 1995 Taurus Sable?

given that you have general knowledge on socket tools/wrenches. all you need to do is locate the drain pipe usually on the bottom or bottom side of the radiator. make sure its fully drained so you dont make a big mess. take off the fan cover. locate the bolts holding the radiator in place remove said bolts. remove said radiator do steps in reverse to replace. congratulations you replaced a radiator!!! well done. p.s dont for get to refill the radiator ;)


How do you replace the water pump in a 2004 Jeep liberty Sport 2.4 Liter 4 cylinder?

There are fourteen steps on how to replace the water pump in a 2004 Jeep Liberty Sport 2.4 liter 4 cylinder. Some of the step-by-step instructions are set the drain pan underneath the radiator's drain plug, drain the radiator, and then use a wrench to twist the radiator plug counterclockwise.


How do you change thermostat in 88' Chevy c2500?

Drain the radiator. Remove the top hose, and the water inlet. Remove the thermostat from under the inlet, and replace it. Reverse the steps to finish the installation.


How do you replace the radiator on a 1996 Dodge Stratus 4-cylinder 4 door front wheel drive car?

You have to drain the coolant either from the radiator drain or disconnecting the lower hose. You then have to disconnect/unbolt the electric fan. The coolant hoses at the radiator needs to be disconnected. Lastly the radiator needs to be unbolted, then lifted out. The new radiator can be installed the steps reversed, coolant topped off and bleed of any air.


How do you replace a 1992 Toyota pickup radiator?

first drain all anti freeze out of your radiator then undo fan shroud. Next you will have to undo radiator hoses supply and return, then undo the four bolts holding the radiator in once bolts are out just slide it right out the top. TIP: when putting radiator hoses back on or taking them off spraying WD-40 inside the hoses will make putting them back on or taking them off easier. To put radiator in repeat steps backwards.


What steps do you take to correctly replace the entire radiator on a 1997 Acura TL?

1.drain engine coolant 2.remove the upper and lower radiator hoses, and the atf cooler hoses 3.disconnect the fan motor connectors and ect switch connector 4.remove the radiator upper brackets, then pull up the radiator 5.remove the fan shroud assemblies and other parts from the radiator install the radiator in the reverse order of removal set the upper and lower cushions securely fill the radiator with engine coolant and bleed air


How do you change the water pump on a 2001 gmc Yukon Denali?

There are several steps to changing a water pump in a 2001 GMC Yukon Denali. You must first make sure the engine is cool, and drain the radiator of coolant. You will then need to remove the air duct and housing. You will also need to move or remove the radiator hose, radiator fan shroud, serpentine belt from the alternator, water pump pulley, and old pump gasket?æto access the water pump. You can then replace the water pump, and then replace the parts that you removed.


How to replace concrete preformed steps?

Jackhammer old steps and put rubble in dumpster. Have new preformed steps delivered and emplaced.


What is the first thing to check or replace on a 2002 Sentra that overheats when fan and temperature sensor working properly?

Check the coolant levels in both the radiator and its reservoir. Check that the radiator cooling fins are clean enough for air to pass. Make sure the hoses are not kinked or bulged. Make sure there is a fan shroud equipped. Replace the radiator cap (should be replaced every few years anyways and they're fairly cheap). Check the weep hole on the water pump, if you see any sign of coolant leakage from it, it probably has failed or will soon, replace it. Then start the more involved steps if none of the above applies. Drain the rad. Remove the upper and lower rad hoses and check the hoses and all visible orifices for obstructions, replace if necessary. Replace the thermostat. Replace the water pump if it is determined that it is not functioning.