answersLogoWhite
Cars & Vehicles
Dodge Stratus
VW New Beetle
Ford Ranger XLT

How do you replace the radiator on a 1996 Dodge Stratus 4-cylinder 4 door front wheel drive car?

181920

Top Answer
User Avatar
Wiki User
2015-03-05 23:46:53
2015-03-05 23:46:53

You have to drain the coolant either from the radiator drain or disconnecting the lower hose. You then have to disconnect/unbolt the electric fan. The coolant hoses at the radiator needs to be disconnected. Lastly the radiator needs to be unbolted, then lifted out. The new radiator can be installed the steps reversed, coolant topped off and bleed of any air.

1

Related Questions

User Avatar

Where is the cool fan relay on a dodge stratus and how do you replace it

User Avatar

How much should it cost to replace the airbags on a 1997 dodge stratus?

User Avatar

Look on the bottom or rear of radiator

User Avatar

The "radiator" cap is located on the coolant reservoir.

User Avatar

I changed mine on 1996 stratus 2.4l 4cylinder it is underneath on right side and has a rubber hard cover on it .

User Avatar

open the drain at the bottom of the radiator and remove cap

User Avatar

Reservoir tank feeds the radiator. It's a Dodge thing.

User Avatar

The thermostat is under the housing where the upper radiator hose attaches to the engine on a 2.4 liter Dodge Stratus.

User Avatar

I had to replace the engine in my 2001 stratus SE and it ran me 900 dollars.

User Avatar

The thermostat on a 2.5 L Dodge Stratus is located under the housing where the lower radiator hose attaches to the engine.

User Avatar

Four cylinder, under the housing where the upper radiator hose attaches. Six cylinder, under the housing where the lower radiator hose attaches to the engine.

User Avatar

change an alternator in a dodge 2006

User Avatar

no the 1996 -1998 is the same then the 2000-2004 is the same so it will not fit

User Avatar

I installed a radiator in my wifes 2000 Dodge Stratus. What I done was buy a Hayes repair manuel. The air conditioning condensor is attached to the radiator . It was not a easy job for me but if you got smaller hands than me it mite not be so bad.

User Avatar

where is the manifold located on the 2004 dodge stratus 2.7l

User Avatar

first of all, take it to a dealer and have them do whatever you need to be done?!?!

User Avatar

Follow the top radator hose to where it connects to the motor. On my 97 stratus you follow the top hose which leads to peice where the radiator cap turns on, take out the 2 bolts and underneath is your thermostat.

User Avatar

The IAT sensor on a 2004 Dodge Stratus 2.4L is located where the radiator hose meets the engine. IAT stands for intake air temperature.

User Avatar

You put it in the coolant reservoir, a plastic container with a radiator cap on it

User Avatar

Lower radiator hose at the engine block. Most Dodges have it there.

User Avatar

Dodge Stratus was created in 1995.

User Avatar

The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.

User Avatar

It is at the end of the lower radiator hose on the motor. You will have to empty the radiator and remove the housing to replace it.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.