The Camshaft Position Sensor is used for ignition timing and determining the RPM.
As the signal is needed for proper fuel injection, the fuel injection stops whenever there is no signal. Also the RPM meter drops to zero.
It is possible that the signal drops out for one or two seconds, and then resumes. In this case the engine will stall during the dropout, and (when not in idle) resume operation when the signal resumes. It is very well possible that no error condition is logged by the Engine Control Unit (ECU).
If the signal is completely gone the engine will not run or start. In this case an error code will be logged.
It is important to recognize when poor performance is due to a bad car part. Symptoms of a bad camshaft sensor are misfiring, hesitation during acceleration, and not starting.
Where is the camshaft position sensor on a 2005 Expedition?
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
No start, dies off, cuts out.
location of the camshaft sensor
Do you have a video of the hhr camshaft position sensor
There isn't a camshaft position sensor. If you are asking because of an error code you received, it is caused by a signal that mimics the same signal as a camshaft position sensor.
The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
The Camshaft sensor is located in the distributor.
Some will run rough and not run at all.
no